STM32F303VE datasheet(31/184 Pages) STMICROELECTRONICS

31 / 184 page

DocID026415 Rev 4

31/184

STM32F303xD STM32F303xE

Functional overview

3.23

Serial peripheral interface (SPI)/Inter-integrated sound

interfaces (I2S)

Up to four SPIs are able to communicate up to 18 Mbit/s in slave and master modes in full-

duplex and half-duplex communication modes. The 3-bit prescaler gives 8 master mode

frequencies and the frame size is configurable from 4 bits to 16 bits.

Two standard I2S interfaces (multiplexed with SPI2 and SPI3) supporting four different

audio standards can operate as master or slave at half-duplex and full duplex

communication modes. They can be configured to transfer 16 and 24 or 32 bits with 16-bit

or 32-bit data resolution and synchronized by a specific signal. Audio sampling frequency

from 8 kHz up to 192 kHz can be set by 8-bit programmable linear prescaler. When

operating in master mode it can output a clock for an external audio component at 256 times

the sampling frequency.

Refer to Table 9 for the features available in SPI1, SPI2, SPI3 and SPI4.

3.24

Controller area network (CAN)

The CAN is compliant with specifications 2.0A and B (active) with a bit rate up to 1 Mbit/s. It

can receive and transmit standard frames with 11-bit identifiers as well as extended frames

with 29-bit identifiers. It has three transmit mailboxes, two receive FIFOs with 3 stages and

14 scalable filter banks.

3.25

Universal serial bus (USB)

The STM32F303xD/E embeds a full-speed USB device peripheral compliant with the USB

specification version 2.0. The USB interface implements a full-speed (12 Mbit/s) function

interface with added support for USB 2.0 Link Power Management. It has software-

configurable endpoint setting with packet memory up-to 1 Kbyte (256 bytes are used for

CAN peripheral if enabled) and suspend/resume support.

The dedicated 48 MHz clock is generated from the internal main PLL (the clock source must

use a HSE crystal oscillator).

Table 9. STM32F303xD/E SPI/I2S implementation

SPI features(1)

SPI1

SPI2

SPI3

SPI4

Hardware CRC calculation

XXXX

Rx/Tx FIFO

XXXX

NSS pulse mode

XXXX

I2S mode

TI mode

XXXX

1. X = supported.

STM32F303VE датащи(PDF) 31 Page - STMicroelectronics

STM32F303VE датащи(HTML) 31 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

датащи скачать

ссылки URL