Tel:+86-755-82973805

Fax: +86-755-82973550

Email:sales@hoperf.com

http://www.hoperf.com

13

4.1. Relative Humidity Sensor Accuracy

To determine the accuracy of a relative humidity sensor, it is placed in a temperature and humidity controlled

chamber. The temperature is set to a convenient fixed value (typically 25–30 °C) and the relative humidity is swept

from 20 to 80% and back to 20% in the following steps: 20% – 40% – 60% – 80% – 80% – 60% – 40% – 20%. At

each set-point, the chamber is allowed to settle for a period of 60 minutes before a reading is taken from the

sensor. Prior to the sweep, the device is allowed to stabilize to 50%RH. The solid trace in Figure 6, “Measuring

Sensor Accuracy Including Hysteresis,” shows the result of a typical sweep.

Figure 6.

Measuring Sensor Accuracy Including Hysteresis

The RH accuracy is defined as the dotted line shown in Figure 6, which is the average of the two data points at

each relative humidity set-point. In this case, the sensor shows an accuracy of 0.25%RH. The TH06 accuracy

specification (Table 4) includes:



Unit-to-unit and lot-to-lot variation



Accuracy of factory calibration



Margin for shifts that can occur during solder reflow

The accuracy specification does not include:



Hysteresis (typically ±1%)



Effects from long term exposure to very humid conditions



Contamination of the sensor by particulates, chemicals, etc.



Other aging related shifts ("Long-term stability")



Variations due to temperature (see Drift vs. Temperature in Table 4). RH readings will typically vary with

temperature by less than