PIC16F84A-10SLASHP datasheet(73/124 Pages) MICROCHIP

73 / 124 page

PIC16F83/84

PIC16F8X

DS30430C-page 73

10.0

ELECTRICAL CHARACTERISTICS FOR PIC16F83 AND PIC16F84

Absolute Maximum Ratings †

Ambient temperature under bias.............................................................................................................-55

°C to +125°C

Storage temperature .............................................................................................................................. -65

°C to +150°C

Voltage on VDD with respect to VSS .......................................................................................................... -0.3 to +7.5V

Voltage on MCLR with respect to VSS(2) ...................................................................................................... -0.3 to +14V

Voltage on any pin with respect to VSS (except VDD and MCLR).................................................... -0.6V to (VDD + 0.6V)

Total power dissipation(1) .....................................................................................................................................800 mW

Maximum current out of VSS pin ...........................................................................................................................150 mA

Maximum current into VDD pin ..............................................................................................................................100 mA

Input clamp current, IIK (VI < 0 or VI > VDD)

.....................................................................................................................± 20 mA

Output clamp current, IOK (VO < 0 or VO > VDD)

.............................................................................................................± 20 mA

Maximum output current sunk by any I/O pin..........................................................................................................25 mA

Maximum output current sourced by any I/O pin ....................................................................................................20 mA

Maximum current sunk by PORTA ..........................................................................................................................80 mA

Maximum current sourced by PORTA .....................................................................................................................50 mA

Maximum current sunk by PORTB........................................................................................................................150 mA

Maximum current sourced by PORTB...................................................................................................................100 mA

Note 1: Power dissipation is calculated as follows: Pdis = VDD x {IDD -

∑ IOH} + ∑ {(VDD-VOH) x IOH} + ∑(VOl x IOL)

Note 2: Voltage spikes below VSS at the MCLR pin, inducing currents greater than 80 mA, may cause latch-up. Thus,

a series resistor of 50-100

Ω should be used when applying a “low” level to the MCLR pin rather than pulling

this pin directly to VSS.

† NOTICE: Stresses above those listed under “Absolute Maximum Ratings” may cause permanent damage to the

device. This is a stress rating only and functional operation of the device at those or any other conditions above

those indicated in the operation listings of this speciﬁcation is not implied. Exposure to maximum rating conditions

for extended periods may affect device reliability.

PIC16F84A-10/P датащи(PDF) 73 Page - Microchip Technology

PIC16F84A-10/P датащи(HTML) 73 Page - Microchip Technology

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

датащи скачать

ссылки URL