RF69 datasheet(39/81 Pages) ETC2

39 / 81 page

RF69

Page 39

Tel: +86-755-82973805 Fax: +86-755-82973550 E-mail: sales@hoperf.com http://www.hoperf.com

4.2.4. Rx Start Procedure

As described in the former sections, the RxReady interrupt warns the uC that the receiver is ready.

 In Continuous mode with Bit Synchronizer, the receiver will start locking its Bit Synchronizer on a minimum or 12 bits of

received preamble (see section 3.4.13 for details), before the reception of correct Data, or Sync Word (if enabled) can

occur.

 In Continuous mode without Bit Synchronizer, valid data will be available on DIO2/DATA right after the RxReady

interrupt.

 In Packet mode, the receiver will start locking its Bit Synchronizer on a minimum or 12 bits of received preamble (see

section 3.4.13 for details), before the reception of correct Data, or Sync Word (if enabled) can occur.

4.2.5. Optimized Frequency Hopping Sequences

In a frequency hopping-like application, it is required to turn off the transmitter when hopping from one channel to another,

to avoid spectral splatter and obtain the best spectral purity.

 Transmitter hop from Ch A to Ch B: it is advised to step through the Rx mode:

(0) RF69 is in Tx mode in Ch A

(1) Program the RF69 in Rx mode

(2) Change the carrier frequency in the RegFrf registers

(3) Turn the transceiver back to Tx mode

(4) Respect the Tx start procedure, described in section 4.2.2

 Receiver hop from Ch A to Ch B:

(0) RF69 is in Rx mode in Ch A

(1) Change the carrier frequency in the RegFrf registers

(2) Program the RF69 in FS mode

(3) Turn the transceiver back to Rx mode

(4) Respect the Rx start procedure, described in section 4.2.4

Note

all sequences described above are assuming that the sequencer is turned on (SequencerOff=0 in RegOpMode).

RF69 датащи(PDF) 39 Page - List of Unclassifed Manufacturers