RF65 datasheet(38/72 Pages) ETC2

38 / 72 page

Page 38

RF65

Tel: +86-755-82973805 Fax: +86-755-82973550 E-mail: sales@hoperf.com http://www.hoperf.com

ADVANCED COMMUNICATIONS & SENSING

DATASHEET

5.2. Control Block Description

5.2.1. SPI Interface

The SPI interface gives access to the configuration register via a synchronous full-duplex protocol corresponding to CPOL

= 0 and CPHA = 0 in Motorola/Freescale nomenclature. Only the slave side is implemented.

Three access modes to the registers are provided:



SINGLE access: an address byte followed by a data byte is sent for a write access whereas an address byte is sent and

a read byte is received for the read access. The NSS pin goes low at the begin of the frame and goes high after the data

byte.



BURST access: the address byte is followed by several data bytes. The address is automatically incremented internally

between each data byte. This mode is available for both read and write accesses. The NSS pin goes low at the

beginning of the frame and stay low between each byte. It goes high only after the last byte transfer.



FIFO access: if the address byte corresponds to the address of the FIFO, then succeeding data byte will address the

FIFO. The address is not automatically incremented but is memorized and does not need to be sent between each data

byte. The NSS pin goes low at the beginning of the frame and stay low between each byte. It goes high only after the

last byte transfer.

Figure below shows a typical SPI single access to a register.

Figure 21. SPI Timing Diagram (single access)

MOSI is generated by the master on the falling edge of SCK and is sampled by the slave (i.e. this SPI interface) on the

rising edge of SCK. MISO is generated by the slave on the falling edge of SCK.

A transfer always starts by the NSS pin going low. MISO is high impedance when NSS is high.

The first byte is the address byte. It is made of:



wnr bit, which is 1 for write access and 0 for read access



7 bits of address, MSB first

The second byte is a data byte, either sent on MOSI by the master in case of a write access, or received by the master on

MISO in case of read access. The data byte is transmitted MSB first.

Proceeding bytes may be sent on MOSI (for write access) or received on MISO (for read access) without rising NSS and

re-sending the address. In FIFO mode, if the address was the FIFO address then the bytes will be read at the FIFO

address. In Burst mode, if the address was not the FIFO address, then it is automatically incremented at each new byte

received.

RF65 датащи(PDF) 38 Page - List of Unclassifed Manufacturers