CMX608 datasheet(50/70 Pages) CMLMICRO

50 / 70 page

RALCWI Vocoder

CMX608/CMX618/CMX638

 2014 CML Microsystems Plc

D/608_18_38/11

Bit 15 If this bit is clear, the low watermark will be set from the supplied watermark value.

In addition, the device will be set to notify as soon as the low watermark condition exists

(which may be immediately, depending on the sample count).

If this bit is set, the high watermark will be set from the supplied watermark value. In

addition, the device will be set to wait until the high watermark condition exists (which may

be immediately, depending on the sample count) before allowing the low watermark

condition to be signalled.

IRQENAB register address $1F

RDY

SVC

VDW

PLV

DFDA

EFDA

VDA

This write-only register specifies which of the bits in the STATUS register ($40) will cause a C-BUS

interrupt to be generated (IRQN pin is pulled low).

Setting a bit to '1' will cause the corresponding status bit to generate a C-BUS interrupt when the

status bit is set to '1'. Please refer to the STATUS register ($40) for an explanation of the bits.

The default state of this register after a power-up reset is for all bits, except for bit 15 (RDY), to be

cleared to '0'. Bit 15 is set to '1', so that when the device is ready to accept commands (signified

by bit 15 (RDY) of the STATUS register ($40) being set to '1'), there will also be a C-BUS interrupt.

CMX608 датащи(PDF) 50 Page - CML Microcircuits