LTC2400CS8 datasheet(19/40 Pages) LINER

19 / 40 page

LTC2400

APPLICATIONS INFORMATION

HIGH state. This will cause the device to exit the internal

serial clock mode on the next falling edge of CS. This can

be avoided by adding an external 10k pull-up resistor to

the SCK pin or by never pulling CS HIGH when SCK is LOW.

Whenever SCK is LOW, the LTC2400’s internal pull-up at

pin SCK is disabled. Normally, SCK is not externally driven

if the device is in the internal SCK timing mode. However,

certain applications may require an external driver on SCK.

If this driver goes HI-Z after outputting a LOW signal, the

LTC2400’s internal pull-up remains disabled. Hence, SCK

remains LOW. On the next falling edge of CS, the device is

switched to the external SCK timing mode. By adding an

external 10k pull-up resistor to SCK, this pin goes HIGH

once the external driver goes HI-Z. On the next CS falling

edge, the device will remain in the internal SCK timing

mode.

A similar situation may occur during the sleep state when

CS is pulsed HIGH-LOW-HIGH in order to test the conver-

sion status. If the device is in the sleep state (EOC = 0), SCK

will go LOW. Once CS goes HIGH (within the time period

defined above as tEOCtest), the internal pull-up is activated.

For a heavy capacitive load on the SCK pin, the internal

pull-up may not be adequate to return SCK to a HIGH level

before CS goes low again. This is not a concern under

normal conditions where CS remains LOW after detecting

EOC = 0. This situation is easily overcome by adding an

external 10k pull-up resistor to the SCK pin.

Internal Serial Clock, 2-Wire I/O,

Continuous Conversion

This timing mode uses a 2-wire, all output (SCK and SDO)

interface. The conversion result is shifted out of the device

by an internally generated serial clock (SCK) signal, see

Figure 10. CS may be permanently tied to ground (Pin 4),

simplifying the user interface or isolation barrier.

The internal serial clock mode is selected at the end of the

power-on reset (POR) cycle. The POR cycle is concluded

approximately 0.5ms after VCC exceeds 2.2V. An internal

weak pull-up is active during the POR cycle; therefore, the

internal serial clock timing mode is automatically selected

if SCK is not externally driven LOW (if SCK is loaded such

that the internal pull-up cannot pull the pin HIGH, the

external SCK mode will be selected).

SDO

SCK

(INTERNAL)

LSB24

MSB

EXR

SIG

BIT 4

BIT 0

BIT 27

BIT 26

BIT 28

BIT 29

BIT 30

EOC

BIT 31

SLEEP

DATA OUTPUT

CONVERSION

2400 F10

VCC

VREF

SCK

VIN

SDO

GND

VREF

0.1V TO VCC

VIN

–0.12VREF TO 1.12VREF

µF

2.7V TO 5.5V

LTC2400

= 50Hz REJECTION

= EXTERNAL OSCILLATOR

= 60Hz REJECTION

VCC

Figure 10. Internal Serial Clock, Continuous Operation

LTC2400CS8 датащи(PDF) 19 Page - Linear Technology

LTC2400CS8 датащи(HTML) 19 Page - Linear Technology

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40

датащи скачать

ссылки URL