| поискавой системы для электроныых деталей |
|
PM0214 датащи(PDF) 186 Page - STMicroelectronics |
|
|
|||||||||||||||||||||||||||||
PM0214 датащи(HTML) 186 Page - STMicroelectronics |
|
186 / 245 page ![]() Core peripherals PM0214 186/245 DocID022708 Rev 4 4.2.6 MPU control register (MPU_CTRL) Address offset: 0x04 Reset value: 0x0000 0000 Required privilege: Privileged The MPU_CTRL register: • Enables the MPU • Enables the default memory map background region • Enables use of the MPU when in the hard fault, Non-maskable Interrupt (NMI), and FAULTMASK escalated handlers. When ENABLE and PRIVDEFENA are both set to 1: • For privileged accesses, the default memory map is as described in Section 2.2: Memory model on page 27. Any access by privileged software that does not address an enabled memory region behaves as defined by the default memory map. • Any access by unprivileged software that does not address an enabled memory region causes a memory management fault. XN and Strongly-ordered rules always apply to the System Control Space regardless of the value of the ENABLE bit. When the ENABLE bit is set to 1, at least one region of the memory map must be enabled for the system to function unless the PRIVDEFENA bit is set to 1. If the PRIVDEFENA bit is set to 1 and no regions are enabled, then only privileged software can operate. When the ENABLE bit is set to 0, the system uses the default memory map. This has the same memory attributes as if the MPU is not implemented, see Table 13: Memory access behavior on page 29. The default memory map applies to accesses from both privileged and unprivileged software. When the MPU is enabled, accesses to the System Control Space and vector table are always permitted. Other areas are accessible based on regions and whether PRIVDEFENA is set to 1. Unless HFNMIENA is set to 1, the MPU is not enabled when the processor is executing the handler for an exception with priority –1 or –2. These priorities are only possible when handling a hard fault or NMI exception, or when FAULTMASK is enabled. Setting the HFNMIENA bit to 1 enables the MPU when operating with these two priorities. 31 3029 28 27 26 25 24 23 22 21 20 19 18 17 16 Reserved 15 14 13 12 11 10 9 8 76 54 3 21 0 Reserved rw rw rw |
|
ссылки URL |
| Вашему бизинису помогли Аллдатащит? [ DONATE ] |
Что такое Аллдатащит | реклама | контакт | Конфиденциальность | Ссылка на техническое описание | обмен ссыками | поиск по производителю All Rights Reserved©Alldatasheet.com |
| Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
|
Family Site : ic2ic.com |
icmetro.com |