CS5361

8

3.2.2

Slave Mode

LRCK and SCLK operate as inputs in Slave mode. The left/right clock must be synchronously derived

from the master clock and be equal to Fs. It is also recommended that the serial clock be synchronously

derived from the master clock and be equal to 64x Fs to maximize system performance. Refer to Table 3

for required clock ratios.

Table 3. CS5361 Slave Mode Clock Ratios

3.3

Power-up Sequence

Reliable power-up can be accomplished by keeping the device in reset until the power supplies, clocks and

configuration pins are stable. It is also recommended that reset be enabled if the analog or digital supplies

drop below the minimum specified operating voltages to prevent power glitch related issues.

The internal reference voltage must be stable for the device to produce valid data. Therefore, there is a de-

lay between the release of reset and the generation of valid output, due to the finite output impedance of

FILT+ and the presence of the external capacitance.

3.4

Analog Connections

The analog modulator samples the input at 6.144 MHz (MCLK=12.288 MHz). The digital filter will reject

signals within the stopband of the filter. However, there is no rejection for input signals which are

(n

gested filter that will attenuate any noise energy at 6.144 MHz, in addition to providing the optimum

source impedance for the modulators. The use of capacitors which have a large voltage coefficient (such

as general purpose ceramics) must be avoided since these can degrade signal linearity.

Please see the Addendum at the end of the datasheet for an analog input buffer that can be used with both

the CS5351 as well as the CS5361 with a simple change in the bill of materials.

Single Speed Mode

Fs = 2kHz to 50kHz

Double Speed Mode

Fs = 50kHz to 100kHz

Quad Speed Mode

Fs = 100kHz to 192kHz

MCLK/LRCK Ratio

256x, 512x

128x, 256x

128x, 256x

SCLK/LRCK Ratio

32x, 64x, 128x

32x, 64x

64x