CS42L50 datasheet(24/48 Pages) CIRRUS

24 / 48 page

CS42L50

DS544PP1

Ramped Digital and Analog

Soft Ramp allows digital level changes, both muting and attenuation, to be implemented by incrementally

ramping, in 1/8 dB steps, from the current level to the new level at a rate of 1 dB per 8 left/right clock pe-

riods. Analog level changes will occur in 1 dB steps on a signal zero crossing. The analog level change

will occur after a timeout period of 512 sample periods (10.7 ms at 48 kHz sample rate) if the signal does

not encounter a zero crossing. The zero cross function is independently monitored and implemented for

each channel.

Note:

Ramped Digital and Analog is not available in Double Speed Mode.

4.2.4 POWER DOWN HEADPHONE AMPLIFIER (PDNHP)

Default = 0

0 - Disabled

1 - Enabled

Function:

The headphone amplifier will independently enter a low-power state when this function is enabled.

4.2.5 POWER DOWN LINE AMPLIFIER (PDNLN)

Default = 0

0 - Disabled

1 - Enabled

Function:

The line output amplifier will independently enter a low-power state when this function is enabled.

4.2.6 POWER DOWN (PDN)

Default = 1

0 - Disabled

1 - Enabled

Function:

The entire DAC device will enter a low-power state when this function is enabled, and the contents of the

control registers are retained in this mode. The power-down bit defaults to ‘enabled’ on power-up and

must be disabled before normal operation will begin.

4.2.7 CONTROL PORT ENABLE (CP_EN)

Default = 0

0 - Disabled

1 - Enabled

Function:

The DAC will enter control port mode when this bit is enabled. This bit must be set prior to writing to the

control port.

CS42L50 датащи(PDF) 24 Page - Cirrus Logic