AD5686 datasheet(18/28 Pages) AD

18 / 28 page

AD5686/AD5684

Data Sheet

Rev. A | Page 18 of 28

THEORY OF OPERATION

DIGITAL-TO-ANALOG CONVERTER

The AD5686/AD5684 are quad, 16-/12-bit, serial input, voltage

output DACs. The parts operate from supply voltages of 2.7 V to

5.5 V. Data is written to the AD5686/AD5684 in a 24-bit word

format via a 3-wire serial interface. The AD5686/AD5684

incorporate a power-on reset circuit to ensure that the DAC

output powers up to a known output state. The devices also

have a software power-down mode that reduces the typical

current consumption to typically 4 µA.

TRANSFER FUNCTION

Because the input coding to the DAC is straight binary, the ideal

output voltage when using an external reference is given by









REF

OUT

Gain

where:

D is the decimal equivalent of the binary code that is loaded to

the DAC register as follows:

0 to 4095 for the 12-bit device.

0 to 65,535 for the 16-bit device.

N is the DAC resolution.

VREF is the value of the external reference.

Gain is the gain of the output amplifier and is set to 1 by default.

The gain can be set to ×1 or ×2 using the gain select pin. When

this pin is tied to GND, all four DAC outputs have a span of 0 V

to VREF. When this pin is tied to VDD, all four DAC outputs have

a span of 0 V to 2 × VREF.

DAC ARCHITECTURE

The DAC architecture consists of a string DAC followed by an

output amplifier. Figure 36 shows a block diagram of the DAC

architecture.

Figure 36. Single DAC Channel Architecture Block Diagram

The resistor string structure is shown in Figure 37. It is a string

of resistors, each of Value R. The code loaded to the DAC register

determines the node on the string where the voltage is to be

tapped off and fed into the output amplifier. The voltage is

tapped off by closing one of the switches connecting the

string to the amplifier. Because the DAC is a string of resistors,

it is guaranteed monotonic.

Figure 37. Resistor String Structure

Output Amplifiers

The output buffer amplifier can generate rail-to-rail voltages on

its output, which gives an output range of 0 V to VDD. The actual

range depends on the value of VREF, the GAIN pin, offset error,

and gain error. The GAIN pin selects the gain of the output.

•

If this pin is tied to GND, all four outputs have a gain of 1,

and the output range is 0 V to VREF.

•

If this pin is tied to VDD, all four outputs have a gain of 2,

and the output range is 0 V to 2 × VREF.

These amplifiers are capable of driving a load of 1 kΩ in parallel

with 2 nF to GND. The slew rate is 0.8 V/µs with a ¼ to ¾ scale

settling time of 5 µs.

INPUT

DAC

RESISTOR

STRING

REF (+)

VREF

GND

REF (–)

VOUTX

GAIN

(GAIN = 1 OR 2)

TO OUTPUT

AMPLIFIER

VREF

AD5686 датащи(PDF) 18 Page - Analog Devices

AD5686 датащи(HTML) 18 Page - Analog Devices

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28

датащи скачать

ссылки URL