AM79C982 datasheet(21/26 Pages) AMD

21 / 26 page

AMD

PRELIMINARY

1–23

Am79C982

Minimum Mode

The Minimum Mode reconfigures the bIMR device Man-

agement Port and is intended to provide support for the

low end, non-managed repeaters, requiring minimal ex-

ternal logic to provide LED indication of:

s Twisted Pair Ports Link Status indication and AUI

Loopback Status

s Port Partitioning Status

s Twisted Pair Ports Receiver Polarity Status and

AUI SQE Test Error Status

s Port Bit Rate Error Status

The Minimum Mode is selected by controlling the state

of the TEST pin while

RST is asserted. If TEST is High

(asserted), while reset is active (

RST LOW), then Mini-

mum Mode is selected. The state of SI pin, at the de-

assertion of the

RST signal, determines whether the

bIMR chip is to be programmed for Automatic Polarity

Detection/Correction.

When entering the Minimum Mode, the TEST input has

to be deasserted on the rising edge of reset. A maximum

delay of 100 ns is allowed to account for slow devices.

The following table summarizes the different modes

available.

Test

Functions

Normal Management Mode

Minimum Mode, Receive

Polarity Correction disabled

Minimum Mode, Receive

Polarity Correction enabled

In Minimum Mode, the SO pin is used to serially output

the various status information based on the state of the

SI and SCLK pins. A summary of the status information

is provided in the following table.

SCLK

SO Output

TP Ports Receive Polarity Status +

AUI SQE Test Error Status.

Bit Rate Error (all ports).

TP Ports Link Status + AUI

LoopBack Status

Port Partitioning Status (all ports)

When SI = 0 then SO will output the related AUI status

bits (LoopBack or SQE), followed by the 8 (4) TP status

bits (Link or Polarity), starting with the TP port 0.

When SI = 1, the Port Partitioning Status or Port Bit Rate

Error Status are scanned out with the AUI first and TP

ports following. TP Port 0 is scanned out first.

Note that the Bit Rate Error, AUI Loopback, and AUI

SQE Test Error status bits stay set until they are

scanned out.

The state of SI and SCLK inputs is checked at the end of

every STR cycle. The rising edge of the X1 clock, occur-

ring before falling edge of STR, is used to strobe in the

state of the SI and SCLK pins.

In this Minimum Mode, the Management Port mode is

not active. To exit the Minimum mode, the bIMR device

must reset into the normal Management Port mode.

Am79C982

bIMR8 Chip

XTAL

OSC

ASYNC

RESET

RST

STR

CLR

1/2 ’74

TCK

SIPO

1/2 ’74

TCK

SCLK

19406B-10

TEST

Figure 3. bIMR8 LED Display Design using Minimum Mode

AM79C982 датащи(PDF) 21 Page - Advanced Micro Devices

AM79C982 датащи(HTML) 21 Page - Advanced Micro Devices

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26

датащи скачать

ссылки URL