DM300018 datasheet(79/115 Pages) MICROCHIP

79 / 115 page

Using the dsPIC30F4011

DS51558A-page 73

11.6

IN-CIRCUIT DEBUGGING

The sample application program is intended to illustrate how the processor and I/O

modules handle the functionality provided on the dsPICDEM 2 Development Board.

The MPLAB ICD 2 In-Circuit Debugger was used to program the sample application

into the dsPIC30F device. You can also use the MPLAB ICD 2 In-Circuit Debugger to

examine this baseline code to determine specific applicability to your application.

The examination process requires that three changes be made to the sample applica-

tion setup.

• The dsPIC30F4011 device must be reprogrammed to recognize the MPLAB ICD

2 as a debugger rather than as a programmer.

• MPLAB IDE must be reconfigured to specify the pins on the dsPIC30F4011

device to be used for debugging.

• The dsPICDEM 2 board must be physically reconfigured to ensure that it connects

the MPLAB ICD 2 debugger to the pins on the dsPIC30F4011 device that were

specified in MPLAB IDE.

The primary programming and debugging functions (PGC/EMUC, PGD/EMUD) on the

dsPIC30F device are multiplexed with other peripheral modules on the device used by

the sample application. Thus it is necessary to use an alternate pair of debugging pins

(EMUC1/EMUD1, EMUC2/EMUD2 or EMUC3/EMUD3) to examine the baseline code

provided in the sample application.

11.6.1

Setting Up MPLAB ICD 2 for Debugging

To change MPLAB ICD 2 from a programmer to a debugger:

From the

Debugger menu, click Select Tool>MPLAB ICD 2 to designate the

MPLAB ICD 2 as the debug tool in MPLAB IDE.

From the

Configure menu, select Configuration Bits... The Configuration Bits

window displays the current configuration settings for the device, as shown in

Figure 11-3.

Change the “Comm Channel Select” parameter to Use EMUC2 and EMUD2.

On the dsPICDEM 2 board, change the setting on switch S3 to turn on EMUC2

and EMUD2.

Remove any jumper on header H7.

Reprogram the dsPIC30F device (

Debugger>Program menu).

On the dsPICDEM 2 board, turn off M ALL on switch S2.

Reset the program and run it. From the

Debugger menu, select Reset>Processor

Reset. Then select Debugger>Run.

DM300018 датащи(PDF) 79 Page - Microchip Technology

DM300018 датащи(HTML) 79 Page - Microchip Technology

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

датащи скачать

ссылки URL