CS3100C18-3PW datasheet(62/73 Pages) AMPHENOL

62 / 73 page

The 10-305200 cable clamp and MS3420A sleeve illustrated are used only on

the rear of MS-A or C type connectors. The 10-74900 clamp and grommet

assembly can only be used on special feed-thru applications involving dummy

shells, part numbers 10-37090 and 10-113276.

ASSEMBLY

Both clamps are shipped from the factory with lubricant

conforming to MIL-G-3278. Remove any dirt or foreign

material from components with ethyl alcohol and relubri-

cate as outlined under “lubrication.” Place the clamping

nut (1) on the wire bundle or cable with the threads facing

toward the connector or dummy shell. Position the

tapered sleeve (2) on the bundle or cable with the narrow

portion toward the clamping nut (1). Next install either the

gland (3) used with the 10-305200 clamp or thread each

wire through the grommet (3) used with the 10-74900

clamp. Dependent on the application, the wire bundle or

cable is fed through the dummy shell, or the wire ends

are soldered to the connector contacts. Move the compo-

nents forward in the reverse order of preliminary assem-

bly. (In applications where grommets (3) are used, seat

the grommet against the undercut in the back shell

before bringing the tapered sleeve (2) up against it).

Insure proper positioning of glands (3) or grommets (3),

tapered sleeves (2) and clamping nuts (1). Tighten the

clamp using a strap wrench until a metal to metal seat is

obtained.

Assembly Instructions

for 10-305200 & 10-74900

cable clamps

10-305200 Cable Clamp & MS3420A Sleeve

1. Clamping Nut

2. Tapered Sleeve

3. Gland

4. Reducing or

Telescoping Sleeve

10-74900 Clamp and Grommet Assembly

1. Clamping Nut

2. Tapered Sleeve

3. Grommet

CS3100C18-3PW датащи(PDF) 62 Page - Amphenol Corporation