IXDN0036 datasheet(21/41 Pages) IXYS

21 / 41 page

ATPWMx Demonstrator Software

6-22

ATAVRFBKIT / EVLD001 User Guide

7597A–AVR–02/06

V_HAVERSINE_CONV

Get back the v_haversine result.

Start the next V_BUS_CONV conversion.

V_BUS_CONV

Get back the v_bus result.

Start the next ZERO_TEN_VOLT_CONV conversion.

ZERO_TEN_VOLT_CONV

Get back the zero_ten_volt_result and make a slipper filter with 512 conversion results.

Start the V_HAVERSINE_CONV, the TEMPERATURE_CONV, or the V_LAMP_CONV

conversion depending on g_time_waiting_since_latest_temperature_conv and

gv_lamp_on.

TEMPERATURE_CONV

Get back the temperature_result.

Start the V_HAVERSINE_CONV or the V_LAMP_CONV conversion depending on

gv_lamp_on.

V_LAMP_CONV

Get back the v_lamp result.

Start the v_haversine or the i_lamp conversion depending on gv_lamp_on and

gv_request_lamp_off.

If a lamp off (gv_request_lamp_off == 1) has been requested by the command control

task or a lamp fault mode on Lamp_ctrl.c file, the PSC2 and the amplifier0 are switched

off and the following variables are set in at the following values:

•

gv_lamp_on = 0;

•

gv_lamp_state = LAMP_OFF;

•

gv_pfc_state =

SHUT_DOWN_PFC_AND_SLOW_DOWN_UC_SPEED;

Then a V_HAVERSINE_CONV conversion is started.

Else an I_LAMP_CONV conversion is started.

IXDN0036 датащи(PDF) 21 Page - IXYS Corporation