CS8415A-CSZ datasheet(33/46 Pages) CIRRUS

33 / 46 page

DS470F4

CS8415A

11.PIN DESCRIPTION - HARDWARE MODE

Pin Name

# Pin Description

COPY

COPY Channel Status Bit (Output) - Reflects the state of the Copyright Channel Status bit in the incoming

AES3 data stream. If the category code is set to General, copyright will be indicated whatever the state of

the Copyright bit.

VL2+

VL+

VL3+

Positive Digital Power (Input) - Typically +3.3 V or +5.0 V.

EMPH

Pre-Emphasis (Output) - EMPH is low when the incoming Channel Status data indicates 50/15 ms pre-

emphasis.

EMPH is high when the Channel Status data indicates no pre-emphasis or indicates pre-empha-

sis other than 50/15 ms. This pin is also a start-up option which, along with ORIG, determines the serial port

format. A 47 k

Ω resistor to either VL+ or DGND is required.

RXP0

RXN0

AES3/SPDIF Receiver Port (Input) - Differential line receiver inputs for the AES3 biphase encoded data.

See Appendix A for recommended circuits.

VA+

Positive Analog Power (Input) - Nominally +5.0 V. This supply should be as quiet as possible since noise

on this pin will directly affect the jitter performance of the recovered clock.

AGND

Analog Ground (Input) - Ground for the analog circuitry in the chip. AGND and DGND should be connected

to a common ground area under the chip.

FILT

PLL Loop Filter (Output) - An RC network should be connected between this pin and ground. See

“Appen-

dix C: PLL Filter” on page 41 for recommended schematic and component values.

RST

Reset (Input) - When RST is low, the CS8415A enters a low power mode and all internal states are reset.

On initial power up, RST must be held low until the power supply is stable, and all input clocks are stable in

frequency and phase. This is particularly true in hardware mode with multiple CS8415A devices where syn-

chronization between devices is important.

CS8415A-CSZ датащи(PDF) 33 Page - Cirrus Logic