WM8731 datasheet(31/56 Pages) WOLFSON

31 / 56 page

WM8731

Advanced Information

WOLFSON MICROELECTRONICS LTD

AI Rev 2.0 February 2001

CRYSTAL OSCILLATOR

The WM8731 includes a crystal oscillator circuit that allows the audio system’s reference clock to be

generated on the device. This is available to the rest of the audio system in buffered form on

CLKOUT. The crystal oscillator is a low radiation type, designed for low EMI. A typical application

circuit is shown in Figure 24.

XTI/MCLK

XTO

DGND

Figure 24 Crystal Oscillator Application Circuit

For crystal frequencies in the 12MHz range, a Cp of 10pF is recommended. For crystal frequencies

in the 18MHz range, 15pF Cp is recommended.

The WM8731 crystal oscillator provides an extremely low jitter clock source. Low jitter clocks are a

requirement for high quality audio ADC and DACs, regardless of the converter architecture. The

WM8731 architecture is less susceptible than most converter techniques but still requires clocks with

less than approximately 1ns of jitter to maintain performance. In applications where there is more

than one source for the master clock, it is recommended that the clock is generated by the WM8731

to minimise such problems.

CLOCKOUT

The Core Clock is internally buffered and made available externally to the audio system on the

CLKOUT output pin. CLKOUT provides a replication of the Core Clock, but buffered as suitable for

driving external loads.

There is no phase inversion between XTI/MCLK, the Core Clock and CLOCKOUT but there will

inevitably be some delay. The delay will be dependent on the load that CLOCKOUT drives. Refer to

Electrical Characteristics.

CLKOUT can also be divided by 2 under software control, refer to Table 13. Note that if CLKOUT is

not required then the CLKOUT buffer on the WM8731 can be safely powered down to conserve

power (see POWER DOWN section). If the system architect has the choice between using FCLKOUT =

FMCLK or FCLKOUT = FMCLK/2 in the interface, the latter is recommended to conserve power. When the

divide by two is selected CLKOUT changes on the rising edge of MCLK. Please refer to Electrical

Characteristics for timing information.

ADDRESS

BIT

LABEL

DEFAULT

DESCRIPTION

0001000

Sampling

Control

CLKODIV2

CLKOUT divider select

1 = CLOCKOUT is Core Clock

divided by 2

0 = CLOCKOUT is Core Clock

Table 13 Programming CLKOUT

CLKOUT is disabled and set low whenever the device is in reset.

WM8731 датащи(PDF) 31 Page - Wolfson Microelectronics plc

WM8731 датащи(HTML) 31 Page - Wolfson Microelectronics plc

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56

датащи скачать

ссылки URL