| поискавой системы для электроныых деталей |
|
ATmega328P датащи(PDF) 261 Page - ATMEL Corporation |
|
|
|||||||||||||||||||||||||||||
ATmega328P датащи(HTML) 261 Page - ATMEL Corporation |
|
261 / 448 page ![]() 261 8161D–AVR–10/09 ATmega48PA/88PA/168PA/328P 23.7 ADC Conversion Result After the conversion is complete (ADIF is high), the conversion result can be found in the ADC Result Registers (ADCL, ADCH). For single ended conversion, the result is where V IN is the voltage on the selected input pin and VREF the selected voltage reference (see Table 23-3 on page 262 and Table 23-4 on page 263). 0x000 represents analog ground, and 0x3FF represents the selected reference voltage minus one LSB. 23.8 Temperature Measurement The temperature measurement is based on an on-chip temperature sensor that is coupled to a single ended ADC8 channel. Selecting the ADC8 channel by writing the MUX3..0 bits in ADMUX register to "1000" enables the temperature sensor. The internal 1.1V voltage reference must also be selected for the ADC voltage reference source in the temperature sensor measurement. When the temperature sensor is enabled, the ADC converter can be used in single conversion mode to measure the voltage over the temperature sensor. The measured voltage has a linear relationship to the temperature as described in Table 23-2. The voltage sensitivity is approximately 1 mV/°C and the accuracy of the temperature measure- ment is +/- 10°C. The values described in Table 23-2 are typical values. However, due to the process variation the temperature sensor output voltage varies from one chip to another. To be capable of achieving more accurate results the temperature measurement can be calibrated in the application soft- ware. The software calibration requires that a calibration value is measured and stored in a register or EEPROM for each chip, as a part of the production test. The software calibration can be done utilizing the formula: T = { [(ADCH << 8) | ADCL] - T OS} / k where ADCn are the ADC data registers, k is a fixed coefficient and T OS is the temperature sen- sor offset value determined and stored into EEPROM as a part of the production test. ADC V IN 1024 ⋅ V REF -------------------------- = Table 23-2. Temperature vs. Sensor Output Voltage (Typical Case) Temperature / °C-45°C+25°C+85°C Voltage / mV 242 mV 314 mV 380 mV |
|
ссылки URL |
| Вашему бизинису помогли Аллдатащит? [ DONATE ] |
Что такое Аллдатащит | реклама | контакт | Конфиденциальность | Ссылка на техническое описание | обмен ссыками | поиск по производителю All Rights Reserved©Alldatasheet.com |
| Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
|
Family Site : ic2ic.com |
icmetro.com |