ATmega328P datasheet(103/448 Pages) ATMEL

103 / 448 page

103

8161D–AVR–10/09

ATmega48PA/88PA/168PA/328P

Figure 14-7. Phase Correct PWM Mode, Timing Diagram

The Timer/Counter Overflow Flag (TOV0) is set each time the counter reaches BOTTOM. The

Interrupt Flag can be used to generate an interrupt each time the counter reaches the BOTTOM

value.

In phase correct PWM mode, the compare unit allows generation of PWM waveforms on the

OC0x pins. Setting the COM0x1:0 bits to two will produce a non-inverted PWM. An inverted

PWM output can be generated by setting the COM0x1:0 to three: Setting the COM0A0 bits to

one allows the OC0A pin to toggle on Compare Matches if the WGM02 bit is set. This option is

not available for the OC0B pin (see Table 14-7 on page 108). The actual OC0x value will only be

visible on the port pin if the data direction for the port pin is set as output. The PWM waveform is

generated by clearing (or setting) the OC0x Register at the compare match between OCR0x and

TCNT0 when the counter increments, and setting (or clearing) the OC0x Register at compare

match between OCR0x and TCNT0 when the counter decrements. The PWM frequency for the

output when using phase correct PWM can be calculated by the following equation:

The N variable represents the prescale factor (1, 8, 64, 256, or 1024).

The extreme values for the OCR0A Register represent special cases when generating a PWM

waveform output in the phase correct PWM mode. If the OCR0A is set equal to BOTTOM, the

output will be continuously low and if set equal to MAX the output will be continuously high for

non-inverted PWM mode. For inverted PWM the output will have the opposite logic values.

At the very start of period 2 in Figure 14-7 OCnx has a transition from high to low even though

there is no Compare Match. The point of this transition is to guarantee symmetry around BOT-

TOM. There are two cases that give a transition without Compare Match.

• OCRnx changes its value from MAX, like in Figure 14-7. When the OCR0A value is MAX the

OCn pin value is the same as the result of a down-counting Compare Match. To ensure

TOVn Interrupt Flag Set

OCnx Interrupt Flag Set

TCNTn

Period

OCnx

(COMnx1:0 = 2)

(COMnx1:0 = 3)

OCRnx Update

OCnxPCPWM

clk_I/O

N 510

⋅

------------------

ATmega328P датащи(PDF) 103 Page - ATMEL Corporation