| поискавой системы для электроныых деталей |
|
ATmega325P датащи(PDF) 165 Page - ATMEL Corporation |
|
|
|||||||||||||||||||||||||||||
ATmega325P датащи(HTML) 165 Page - ATMEL Corporation |
|
165 / 364 page ![]() 165 8023F–AVR–07/09 ATmega325P/3250P • Transmitter Operation. • Transmit Buffer Functionality. • Receiver Operation. However, the receive buffering has two improvements that will affect the compatibility in some special cases: • A second Buffer Register has been added. The two Buffer Registers operate as a circular FIFO buffer. Therefore the UDRn must only be read once for each incoming data! More important is the fact that the Error Flags (FEn and DORn) and the ninth data bit (RXB8n) are buffered with the data in the receive buffer. Therefore the status bits must always be read before the UDRn Register is read. Otherwise the error status will be lost since the buffer state is lost. • The Receiver Shift Register can now act as a third buffer level. This is done by allowing the received data to remain in the serial Shift Register (see Figure 18-1) if the Buffer Registers are full, until a new start bit is detected. The USART is therefore more resistant to Data OverRun (DORn) error conditions. The following control bits have changed name, but have same functionality and register location: • CHR9 is changed to UCSZn2. • OR is changed to DORn. 18.3 Clock Generation The Clock Generation logic generates the base clock for the Transmitter and Receiver. The USART supports four modes of clock operation: Normal asynchronous, Double Speed asyn- chronous, Master synchronous and Slave synchronous mode. The UMSELn bit in USART Control and Status Register C (UCSRnC) selects between asynchronous and synchronous operation. Double Speed (asynchronous mode only) is controlled by the U2Xn found in the UCSRnA Register. When using synchronous mode (UMSELn = 1), the Data Direction Register for the XCK pin (DDR_XCK) controls whether the clock source is internal (Master mode) or external (Slave mode). The XCK pin is only active when using synchronous mode. Figure 18-2 shows a block diagram of the clock generation logic. Figure 18-2. Clock Generation Logic, Block Diagram Signal description: txclk Transmitter clock (Internal Signal). rxclk Receiver base clock (Internal Signal). Prescaling Down-Counter /2 UBRR /4 /2 fosc UBRR+1 Sync Register OSC XCK Pin txclk U2X UMSEL DDR_XCK 0 1 0 1 xcki xcko DDR_XCK rxclk 0 1 1 0 Edge Detector UCPOL |
|
ссылки URL |
| Вашему бизинису помогли Аллдатащит? [ DONATE ] |
Что такое Аллдатащит | реклама | контакт | Конфиденциальность | Ссылка на техническое описание | обмен ссыками | поиск по производителю All Rights Reserved©Alldatasheet.com |
| Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
|
Family Site : ic2ic.com |
icmetro.com |