AT25DF161 datasheet(9/60 Pages) ATMEL

9 / 60 page

3687C–DFLASH–7/09

AT25DF161 [Preliminary]

7. Read Commands

7.1

Read Array

The Read Array command can be used to sequentially read a continuous stream of data from

the device by simply providing the clock signal once the initial starting address has been speci-

fied. The device incorporates an internal address counter that automatically increments on every

clock cycle.

Three opcodes (1Bh, 0Bh, and 03h) can be used for the Read Array command. The use of each

opcode depends on the maximum clock frequency that will be used to read data from the device.

The 0Bh opcode can be used at any clock frequency up to the maximum specified by fCLK, and

the 03h opcode can be used for lower frequency read operations up to the maximum specified

by fRDLF. The 1Bh opcode allows the highest read performance possible and can be used at any

clock frequency up to the maximum specified by fMAX; however, use of the 1Bh opcode at clock

frequencies above fCLK should be reserved to systems employing the RapidS protocol.

To perform the Read Array operation, the CS pin must first be asserted and the appropriate

opcode (1Bh, 0Bh, or 03h) must be clocked into the device. After the opcode has been clocked

in, the three address bytes must be clocked in to specify the starting address location of the first

byte to read within the memory array. Following the three address bytes, additional dummy

bytes may need to be clocked into the device depending on which opcode is used for the Read

Array operation. If the 1Bh opcode is used, then two dummy bytes must be clocked into the

device after the three address bytes. If the 0Bh opcode is used, then a single dummy byte must

be clocked in after the address bytes.

After the three address bytes (and the dummy bytes or byte if using opcodes 1Bh or 0Bh) have

been clocked in, additional clock cycles will result in data being output on the SO pin. The data is

always output with the MSB of a byte first. When the last byte (1FFFFFh) of the memory array

has been read, the device will continue reading back at the beginning of the array (000000h). No

delays will be incurred when wrapping around from the end of the array to the beginning of the

array.

Deasserting the CS pin will terminate the read operation and put the SO pin into a high-imped-

ance state. The CS pin can be deasserted at any time and does not require that a full byte of

data be read.

Figure 7-1.

Read Array – 1Bh Opcode

SCK

MSB

00011011

410 11

812

42 43

37 38

31 32

29 30

47 48

50 51

55 56

OPCODE

AAAA

AAA

MSB

XXXXXXX

MSB

DDDDDDD

ADDRESS BITS A23-A0

DON'T CARE

MSB

XXXXXXX

DON'T CARE

DATA BYTE 1

HIGH-IMPEDANCE

AT25DF161 датащи(PDF) 9 Page - ATMEL Corporation

AT25DF161 датащи(HTML) 9 Page - ATMEL Corporation

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60

датащи скачать

ссылки URL