MCP1801 datasheet(11/26 Pages) MICROCHIP

11 / 26 page

DS22051C-page 11

MCP1801

3.0

PIN DESCRIPTIONS

The descriptions of the pins are listed in Table 3-1.

TABLE 3-1:

MCP1801 PIN FUNCTION TABLE

3.1

Unregulated Input Voltage (VIN)

Connect VIN to the input unregulated source voltage.

Like all low dropout linear regulators, low source

impedance is necessary for the stable operation of the

LDO. The amount of capacitance required to ensure

low source impedance will depend on the proximity of

the input source capacitors or battery type. For most

applications, 0.1 µF of capacitance will ensure stable

operation of the LDO circuit. The type of capacitor used

can be ceramic, tantalum, or aluminum electrolytic. The

low ESR characteristics of the ceramic will yield better

noise and PSRR performance at high-frequency.

3.2

Ground Terminal (GND)

Regulator ground. Tie GND to the negative side of the

output and the negative side of the input capacitor.

Only the LDO bias current (25 µA typical) flows out of

this pin; there is no high current. The LDO output

regulation is referenced to this pin. Minimize voltage

drops between this pin and the negative side of the

load.

3.3

Shutdown Input (SHDN)

The SHDN input is used to turn the LDO output voltage

on and off. When the SHDN input is at a logic-high

level, the LDO output voltage is enabled. When the

SHDN input is pulled to a logic-low level, the LDO

output voltage is disabled and the LDO enters a low

quiescent current shutdown state where the typical

quiescent current is 0.01 µA. The SHDN pin does not

have an internal pull-up or pull-down resistor. The

SHDN pin must be connected to either VIN or GND to

prevent the device from becoming unstable.

3.4

Regulated Output Voltage (VOUT)

Connect VOUT to the positive side of the load and the

positive terminal of the output capacitor. The positive

side of the output capacitor should be physically

located as close to the LDO VOUT pin as is practical.

The current flowing out of this pin is equal to the DC

load current.

Pin No.

SOT-23-5

Name

Function

1VIN

Unregulated Supply Voltage

GND

Ground Terminal

SHDN

Shutdown Input

No Connection

5VOUT

Regulated Voltage Output

MCP1801 датащи(PDF) 11 Page - Microchip Technology

MCP1801 датащи(HTML) 11 Page - Microchip Technology

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26

датащи скачать

ссылки URL