R8C13 datasheet(45/224 Pages) RENESAS

45 / 224 page

Rev.1.20

Jan 27, 2006

page 34 of 205

REJ09B0111-0120

R8C/13 Group

Microcomputer

(Built-in feedback resistor)

XIN

XOUT

Externally derived clock

Open

Vcc

Vss

Microcomputer

(Built-in feedback resistor)

XIN

XOUT

CIN

COUT

(1)

NOTES:

1.Insert a damping resistor if required. The resistance will vary depending on the oscillator and the oscillation drive

capacity setting. Use the value recommended by the maker of the oscillator.

When the oscillation drive capacity is set to low, check that oscillation is stable. Also, if the oscillator manufacturer's

data sheet specifies that a feedback resistor be added external to the chip, insert a feedback resistor between XIN

and XOUT following the instruction.

Figure 6.5 Examples of Main Clock Connection Circuit

The following describes the clocks generated by the clock generation circuit.

6.1 Main Clock

This clock is supplied by a main clock oscillation circuit. This clock is used as the clock source for the

CPU and peripheral function clocks. The main clock oscillator circuit is configured by connecting a

resonator between the XIN and XOUT pins. The main clock oscillator circuit contains a feedback resis-

tor, which is disconnected from the oscillator circuit during stop mode in order to reduce the amount of

power consumed in the chip. The main clock oscillator circuit may also be configured by feeding an

externally generated clock to the XIN pin. Figure 6.5 shows examples of main clock connection circuit.

During reset and after reset, the main clock is turned off.

The main clock starts oscillating when the CM05 bit in the CM0 register is set to “0” (main clock on)

after setting the CM13 bit in the CM1 register to “1” (XIN- XOUT pin).

To use the main clock for the CPU clock, set the OCD2 bit in the OCD register to “0” (selecting main

clock) after the main clock becomes oscillating stably.

The power consumption can be reduced by setting the CM05 bit in the CM0 register to “1” (main clock

off) if the OCD2 bit is set to “1” (on-chip oscillator clock selected).

Note that if an externally generated clock is fed into the XIN pin, the main clock cannot be turned off by

setting the CM05 bit to “1”. If necessary, use an external circuit to turn off the clock.

During stop mode, all clocks including the main clock are turned off. Refer to Section 6.4, “Power

Control.”

6.1 Main Clock

R8C13 датащи(PDF) 45 Page - Renesas Technology Corp

R8C13 датащи(HTML) 45 Page - Renesas Technology Corp

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

датащи скачать

ссылки URL