AD9958SLASHPCBZ datasheet(41/44 Pages) AD

41 / 44 page

AD9958

Rev. A | Page 41 of 44

DESCRIPTIONS FOR CHANNEL REGISTERS

Channel Function Register (CFR)—Address 0x03

Three bytes are assigned to this register.

Table 34. Bit Descriptions for CFR

Bit

Mnemonic

Description

23:22

Amplitude frequency

phase (AFP) select

Controls what type of modulation is to be performed for that channel. See the Modulation Mode section

for details.

21:16

Open

Linear sweep no-dwell

0 = the linear sweep no-dwell function is inactive (default).

1 = the linear sweep no-dwell function is active. If CFR[15] is active, the linear sweep no-dwell function is

activated. See the Linear Sweep Mode section for details. If CFR[14] is clear, this bit is don’t care.

Linear sweep enable

0 = the linear sweep capability is inactive (default).

1 = the linear sweep capability is enabled. When enabled, the delta frequency tuning word is applied to

the frequency accumulator at the programmed ramp rate.

Load SRR at

I/O_UPDATE

0 = the linear sweep ramp rate timer is loaded only upon timeout (timer = 1) and is not loaded because

of an I/O_UPDATE input signal (default).

1 = the linear sweep ramp rate timer is loaded upon timeout (timer = 1) or at the time of an I/O_UPDATE

input signal.

12:11

Open

Must be 0

Must be set to 0.

9:8

DAC full-scale current

control

11 = the DAC is at the largest LSB value (default).

See Table 5 for other settings.

Digital power-down

0 = the digital core is enabled for operation (default).

1 = the digital core is disabled and is in its lowest power dissipation state.

DAC power-down

0 = the DAC is enabled for operation (default).

1 = the DAC is disabled and is in its lowest power dissipation state.

Matched pipe delays

0 = matched pipe delay mode is inactive (default).

active

1 = matched pipe delay mode is active. See the Single-Tone Mode—Matched Pipeline Delay section for

details.

Autoclear sweep

accumulator

0 = the current state of the sweep accumulator is not impacted by receipt of an I/O_UPDATE signal

(default).

1 = the sweep accumulator is automatically and synchronously cleared for one cycle upon receipt of an

I/O_UPDATE signal.

Clear sweep

0 = the sweep accumulator functions as normal (default).

accumulator

1 = the sweep accumulator memory elements are asynchronously cleared.

Autoclear phase

accumulator

0 = the current state of the phase accumulator is not impacted by receipt of an I/O_UPDATE signal

(default).

1 = the phase accumulator is automatically and synchronously cleared for one cycle upon receipt of an

I/O_UPDATE signal.

Clear phase

0 = the phase accumulator functions as normal (default).

accumulator

1 = the phase accumulator memory elements are asynchronously cleared.

Sine wave output

0 = the angle-to-amplitude conversion logic employs a cosine function (default).

enable

1 = the angle-to-amplitude conversion logic employs a sine function.

AD9958/PCBZ датащи(PDF) 41 Page - Analog Devices

AD9958/PCBZ датащи(HTML) 41 Page - Analog Devices

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44

датащи скачать

ссылки URL