Time (s)

Time (s)

OUTA

OUTB

(Channel A)

Hot threshold

(Channel B)

Warm threshold

12

TMP392

SNIS216 – NOVEMBER 2019

www.ti.com

Product Folder Links: TMP392

Submit Documentation Feedback

Copyright © 2019, Texas Instruments Incorporated

Typical Applications (continued)

8.2.1.2 Detailed Design Procedure

The resistor to ground values on the SETA input sets the TTRIP threshold of Channel A. The resistor to ground

value on the SETB input sets the TTRIP threshold of Channel B—as well as the THYST 5°C and 10°C options. TI

recommends that the resistors at SETA and SETB have a 1% tolerance at room temperature. Each resistor can

range from 1.05 K

Ω to 909 KΩ, representing one of 48 unique values. The exact temperature thresholds and trip

points are shown in Table 1 and Table 2. The pullup resistors should be at least 1 kΩ to minimize internal power

dissipation. To get the correct threshold for resistor values, take care to minimize the board level capacitance

and leakage at the SETA and SETB pins.

The waveform for the TMP392 output for hot/warm thresholds is shown in Figure 10. The hysteresis can be set

to 5°C, 10°C, or 20°C. When the temperature exceeds the hot trip point threshold, OUTA goes low until the

temperature drops below the hysteresis threshold. When the temperature exceeds the warm trip threshold,

OUTB goes low and returns high after the temperature drops below the hysteresis threshold. If the switch has

already tripped and the temperature is in the hysteresis band, a POR event will cause the output to go high after

the power is restored.

8.2.1.3 Application Curves

Figure 10. TMP392 Output With Hot/Warm Thresholds and Hysteresis