TMP106

SLLS672A − OCTOBER 2005 − REVISED JANUARY 2006

www.ti.com

2

ABSOLUTE MAXIMUM RATINGS(1)

Power Supply, V+

7.0V

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

Input Voltage(2)

−0.5V to 7.0V

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

Input Current

10mA

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

Operating Temperature Range

−55

°C to +127°C

. . . . . . . . . . . . . . .

Storage Temperature Range

−60

°C to +130°C

. . . . . . . . . . . . . . . . .

Junction Temperature (TJ max)

+150

°C

. . . . . . . . . . . . . . . . . . . . . .

ESD Rating(3):

Human Body Model (HBM)

2000V

. . . . . . . . . . . . . . . . . . . . . . .

Charged-Device Model (CDM)

500V

. . . . . . . . . . . . . . . . . . . . . .

Machine Model (MM)

200V

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

(1) Stresses above these ratings may cause permanent damage.

Exposure to absolute maximum conditions for extended periods

may degrade device reliability. These are stress ratings only, and

functional operation of the device at these or any other conditions

beyond those specified is not supported.

(2) Input voltage rating applies to all TMP106 input voltages.

(3) ESD testing has been tested to TI specifications JEDEC

J−Std 020.

This integrated circuit can be damaged by ESD. Texas

Instruments recommends that all integrated circuits be

handled with appropriate precautions. Failure to observe

proper handling and installation procedures can cause damage.

ESD damage can range from subtle performance degradation to

complete device failure. Precision integrated circuits may be more

susceptible to damage because very small parametric changes could

cause the device not to meet its published specifications.

ORDERING INFORMATION(1)

PACKAGE

PART NUMBER

SYMBOL

Wafer chip-scale package (YZC)

TMP106YZC

F7

(1) For the most current package and ordering information, see the Package Option Addendum at the end of this document, or see the TI website

at www.ti.com.

PIN ASSIGNMENTS

A1

B1

C1

A2

B2

C2

SDA

SCL

V+

GND

ALERT

A0

WCSP−6 PACKAGE

(TOP VIEW)

Note: Pin 1 is determined by orienting the package marking as indicated in the diagram.

(Bump Side Down)