| поискавой системы для электроныых деталей |
|
TMP86FS23UG датащи(PDF) 67 Page - Toshiba Semiconductor |
|
|
|||||||||||||||||||||||||||||
TMP86FS23UG датащи(HTML) 67 Page - Toshiba Semiconductor |
|
67 / 252 page ![]() Page 55 TMP86FS23UG 5.3 Port P3 (P37 to P30) Port P3 is a 3-bit output and a 5-bit input/output port. It is also used as a timer/counter input/output, serial interface input/output or divider output. When used as a timer/counter output, serial interface output or divider output, respective output latch (P3DR) should be set to “1”. It can be selected whether output circuit of P30 to P34 port is C-MOS output or a sink open drain individually, by setting P3OUTCR. When a corresponding bit of P3OUTCR is “0”, the output circuit is selected to a sink open drain and when a corresponding bit of P3OUTCR is “1”, the output circuit is selected to a C-MOS output. When used as an input port, serial interface input or timer/counter input, respective output control (P3OUTCR) should be set to “0” after P3DR is set to “1”. During reset, the P3DR is initialized to “1”, and the P3OUTCR is initialized to “0”. P3 port output latch (P3DR) and P3 port terminal input (P3PRD) are located on their respective address. When read the output latch data, the P3DR should be read and when read the terminal input data, the P3PRD reg- ister should be read. If a read instruction is executed for the P3PRD and the P3OUTCR, read data of bits 7 to 5 are unstable. Figure 5-4 Port P3 Table 5-3 Register Programming for Multi-function ports (P34 to P30) Function Programmed Value P3DR P3OUTCR Port input, serial interface input, or timer counter input “1” “0” Port “0” output “0” Programming for each applications Port “1” output, serial interface output, or timer counter output “1” Table 5-4 Register Programming for Multi-function (P37 to P35) Function Programmed Value P3DR Port “0” output “0” Port “1” output, timer counter output, or divider output “1” Output latch Data input (P3PRD) Output latch read (P3DR) Output latch read (P3DRj) Control input STOP OUTEN STOP OUTEN P3OUTCRi input Control output Control output Data output (P3DR) P3OUTCRi P3i Note: i = 4 to 0 Output latch Data output (P3DRj) P3j Note: j = 7 to 5 D Q D Q D Q |
|
ссылки URL |
| Вашему бизинису помогли Аллдатащит? [ DONATE ] |
Что такое Аллдатащит | реклама | контакт | Конфиденциальность | Ссылка на техническое описание | обмен ссыками | поиск по производителю All Rights Reserved©Alldatasheet.com |
| Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
|
Family Site : ic2ic.com |
icmetro.com |