TMF8805 datasheet(72/74 Pages) OSRAM

72 / 74 page

TMF8805

Laser eye safety

Datasheet

• PUBLIC • Document Feedback

DS000692

• v7-00 • 2023-Dec-01

72 / 74

If the floor life or the temperature/humidity conditions have been exceeded, the devices must

be rebaked prior to solder reflow or dry packing.

Rebaking instructions

When the shelf life or floor life limits have been exceeded, rebake at 50 °C for 12 hours.

Laser eye safety

The TMF8805 is designed to meet the Class 1 laser safety limits including single faults in

compliance with IEC / EN 60825-1:2014 and EN 60825-1:2014/A11:2021. This applies to the

stand-alone device and the included software supplied by ams OSRAM. In an end application

system environment, the system may need to be tested to ensure it remains compliant. The

system must not include any additional lens to concentrate the laser light or parameters set

outside of the recommended operating conditions. Use outside of the recommended condition

or any physical modification to the module during development could result in hazardous levels

of radiation exposure.

Figure 19: Laser eye safety certificate

Complies with 21 CFR 1040.10 and 1040.11 except for conformance with IEC 60825-1 Ed. 3.,

as described in Laser Notice No. 56, dated May 8, 2019.

CAUTION: Use of controls or adjustments or performance of procedures other than those

specified herein may result in hazardous radiation exposure.

Example: Adding a converging lens on top of the TMF8805.

IEC 60825-1:2014 and EN 608

25-1:2014/A11:2021

TMF8805 датащи(PDF) 72 Page - OSRAM GmbH