| поискавой системы для электроныых деталей |
|
CIRCC датащи(PDF) 7 Page - SMSC Corporation |
|
|
|||||||||||||||||||||||||||||
CIRCC датащи(HTML) 7 Page - SMSC Corporation |
|
7 / 70 page ![]() 7 Table 5 - SYSTEM Signals NAME SIZE (BITS) TYPE DESCRIPTION CLK 1 Input System Clock RESET 1 Input CIrCC System Reset CIR_PME 1 Output CIR PME Wake Event Power Down 1 Input Low Power Control DMAEN 1 Output DRQ Tristate Control IRQEN 1 Output IRQ Tristate Control nACE 1 Input ACE 550 Register Bank Select nSCE 1 Input SCE Register Bank Select VCC Power System Supply GND Power System Ground DMAEN DMAEN is used by the chip-level interface to tristate the CIrCC DRQ output when the DMA Enable bit is inactive. The DMA Enable bit is located in SCE Configuration Register B, bit 0. IRQEN IRQEN is used by the chip-level interface to tristate the CIrCC IRQ output when the OUT2 bit is inactive. The OUT2 bit is located in 16C550A MODEM Control Register. Power Down The Power Down pin is used by the chip-level interface to put the SCE into low power mode. Note: Power Down only forces the SCE into low power mode. The ACE power down function is not a part of this specification. CIR_PME CIR_PME is used by a chip-level interface to indicate that a valid NEC control frame has been received and a PME Wake event can be issued. (See the PME WAKE bit in the Consumer IR Control Register in SCE Register Block Two). CHIP-LEVEL CONFIGURATION CONTROLS The following signals come from chip-level configuration registers. There are two types of Chip-Level Configuration Controls: CIrCC- Specific controls, and Legacy Controls. Both types have equivalent controls in either the CIrCC ACE or SCE Registers. The CIrCC-Specific controls have been newly added primarily to support the CIrCC block. Provisions have been made in new chip-level configuration contexts to accommodate these signals. The Legacy controls already exist in other contexts. Provisions have been made in legacy devices to accommodate these controls from either the Chip-Level Configuration Registers or the CIrCC Registers; i.e., the last updated value from either source determines the current control state and is visible in both registers. |
|
ссылки URL |
| Вашему бизинису помогли Аллдатащит? [ DONATE ] |
Что такое Аллдатащит | реклама | контакт | Конфиденциальность | Ссылка на техническое описание | обмен ссыками | поиск по производителю All Rights Reserved©Alldatasheet.com |
| Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
|
Family Site : ic2ic.com |
icmetro.com |