TLP5231

5

8.

8.

8.

8. Recommended Operating Conditions (Note)

Recommended Operating Conditions (Note)

Recommended Operating Conditions (Note)

Recommended Operating Conditions (Note)

Characteristics

Total output supply voltage

Negative output supply voltage

Positive output supply voltage

Positive input supply voltage

Input on-state current

Input off-state voltage

Symbol

(VCC2-VEE)

(VE-VEE)

(VCC2-VE)

VCC1

IF(ON)

VF(OFF)

Note

(Note 1)

(Note 1)

(Note 1)

(Note 2)

(Note 2)

Min

21.5

-15

15

3.3

5.3

0

Typ.













Max

30

-6.5

30 - (VE - VEE)

5.5

12

0.8

Unit

V

V

V

V

mA

V

Note:

The recommended operating conditions are given as a design guide necessary to obtain the intended

performance of the device. Each parameter is an independent value. When creating a system design using

this device, the electrical characteristics specified in this data sheet should also be considered.

Note:

A ceramic capacitor (10 µF) must be connected between pins 9 (VEE) and 13 (VCC2), and a ceramic capacitor

(1 µF) must be connected between pins 13 (VCC2) and 16 (VE), and pins 9 (VEE) and 16 (VE) to stabilize the

operation of the high gain linear amplifier. Failure to provide the bypassing may impair the switching property.

The bypass capacitor should be placed within 1 cm of each pin.

Note 1: If the rising slopes of VCC2 and VEE are so steep, the internal circuit operation may not be stable. In that case

please design the slopes that VCC2 and VEE go up to become 0.1 V/µs or less.

Note 2: The rise and fall times of the input on-current should be less than 0.5 µs.

2020-03-02

Rev.2.0

©2019-2020

Toshiba Electronic Devices & Storage Corporation