5

2047 2.3 10/23/00

SMS44

SUMMIT MICROELECTRONICS, Inc.

PIN DESCRIPTIONS

These inputs are used as the voltage monitor inputs and as

the voltage supply for the SMS44. Internally they are diode

ORed and the input with the highest voltage potential will

be the default supply voltage.

The RESET# output will be true if any one of the four inputs

is above 1V. However, for full device operation at least one

of the inputs must be at 2.7V or higher.

The sensing threshold for each input is independently

programmable in 20mV increments from 0.9V to 6.0V.

Also, the occurrence of an under- or over-voltage condi-

tion that is detected as a result of the threshold setting can

be used to generate subsequent action(s), such as RE-

SET# or IRQ#. The programmable nature of the threshold

voltage eliminates the need for external voltage divider

networks.

PUP#1, PUP#2, PUP#3

These are the power-up permitted outputs when the

SMS44 is programmed to provide the sequencing of LDOs

or DC to DC converters. Each delay is independently

enabled and programmable for its duration (

configura-

tion register 7). If all PUP# outputs are enabled the

PUP#3 turning on to end the sequence.

MR#

The manual reset input always generates a RESET#

output whenever it is driven low. The duration of the

RESET# output pulse will be initiated when MR# goes low

and it will stay low for the duration of MR# low plus the

If MR# is

brought low during a power-on-sequence of the PUP#s the

sequence will be halted for the reset duration, and will then

resume from the point at which it was interrupted. If MR#

is low the configuration registers can be read or written to

≥2.7V.

RESET#

The reset output is an active low open drain output. It will

be driven low whenever the MR# input is low or whenever

an enabled under-voltage or over-voltage condition exists,

or when a longdog timer expiration exists. The four voltage

monitor inputs are always functioning, but their ability to

generate a reset is programmable (

configuration regis-

ter 4). Refer to figures 1 and 2 for a detailed illustration of

levels.

IRQ#

The interrupt output is an active low open-drain output. It

will be driven low whenever the watchdog timer times out

or whenever an enabled under-voltage or over-voltage

condition on a V input exists (

configuration register 6).

Figure 1. RESET# Timing with MR#

MR#

RESET#

tDMRRST

tPRTO

tPRTO

2047 Fig01 1.0

WLDI

Watchdog and longdog timer interrupt input. A low to high

transition on the WLDI input will clear both the watchdog

and longdog timers, effectively starting a new timeout

period.

If WLDI is stuck low and no low-to-high transition is

grammed watch dog timeout) IRQ# will be driven low. If a

transition is still not received within the programmed

be driven low. Refer to Figure 3 for a detailed illustration.

Holding WLDI high will block interrupts from occurring but

will not block the longdog from timing out and generating

a reset. Refer to Figure 4 for a detailed illustration of the

relationship between IRQ#, RESET#, and WLDI.

Figure 2. RESET# Timing with IRQ#

IRQ#

RESET#

tPRTO

VRST

tD

VPTH

2047 Fig02 1.1