STM8L151X6 datasheet(15/147 Pages) STMICROELECTRONICS

15 / 147 page

DS6948 Rev 11

15/147

STM8L151x6/8 STM8L152x6/8

Functional overview

LCD: Liquid crystal display

POR/PDR: Power on reset / power-down reset

RTC: Real-time clock

SPI: Serial peripheral interface

SWIM: Single wire interface module

USART: Universal synchronous asynchronous receiver transmitter

WWDG: Window watchdog

3.1

Low-power modes

The high-density and medium+ density STM8L15xx6/8 devices support five low-power

modes to achieve the best compromise between low-power consumption, short startup time

and available wakeup sources:

•

Wait mode: CPU clock is stopped, but selected peripherals keep running. An internal

or external interrupt or a Reset can be used to exit the microcontroller from Wait mode

(WFE or WFI mode).

•

Low-power run mode: The CPU and the selected peripherals are running. Execution

is done from RAM with a low speed oscillator (LSI or LSE). Flash memory and data

EEPROM are stopped and the voltage regulator is configured in ultra-low-power mode.

The microcontroller enters Low-power run mode by software and can exit from this

mode by software or by a reset.

All interrupts must be masked. They cannot be used to exit the microcontroller from this

mode.

•

Low-power wait mode: This mode is entered when executing a Wait for event in Low-

power run mode. It is similar to Low-power run mode except that the CPU clock is

stopped. The wakeup from this mode is triggered by a Reset or by an internal or

external event (peripheral event generated by the timers, serial interfaces, DMA

controller (DMA1), comparators and I/O ports). When the wakeup is triggered by an

event, the system goes back to Low-power run mode.

All interrupts must be masked. They cannot be used to exit the microcontroller from this

mode.

•

Active-halt mode: CPU and peripheral clocks are stopped, except RTC. The wakeup

can be triggered by RTC interrupts, external interrupts or reset.

•

Halt mode: CPU and peripheral clocks are stopped, the device remains powered on.

The RAM content is preserved. The wakeup is triggered by an external interrupt or

reset. A few peripherals have also a wakeup from Halt capability. Switching off the

internal reference voltage reduces power consumption. Through software configuration

it is also possible to wake up the device without waiting for the internal reference

voltage wakeup time to have a fast wakeup time of 5 µs.

STM8L151X6 датащи(PDF) 15 Page - STMicroelectronics

STM8L151X6 датащи(HTML) 15 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

датащи скачать

ссылки URL