Self-Leveling and DP600NS

7

Procedure for Custom Tapping Concrete:

1.

Dispense 3M™ Scotch-Weld™ Urethane Adhesive DP600 Self-Leveling

or DP600NS into the hole nearly halfway full. To obtain a consistent fill,

judge for under-fill or overfill by counting the number of squeezes of the

trigger.

2.

Insert the bolt or screw within the first 20 seconds after dispensing.

The paste characteristic of 3M™ Scotch-Weld™ Urethane Adhesive

DP600 Self-Leveling or DP600NS will hold the bolt or screw in place

until it cures. Once the work life has been exceeded, do not disturb the

bolt.

3.

Move to the next hole to keep 3M™ Scotch-Weld™ Urethane Adhesive

DP600 Self-Leveling or DP600NS flowing in the mixer tip. If material

sets in the mixer tip, replace the tip and start dispensing again.

4.

3M™ Scotch-Weld™ Urethane Adhesive DP600 Self-Leveling or

DP600NS will become tack-free within 2 minutes and cure within one

hour. Note: It is best to wait for one full hour before extracting the bolt

or screw for securing the cupboards, wall hangers or other cabinetry in

place.

5.

Allow 3M™ Scotch-Weld™ Urethane Adhesive DP600 Self-

Leveling or DP600NS to fully cure before applying a load. The

maximum torque recommended is 9.5 pounds.

Procedures for Custom Tapping Hollow Concrete Blocks, Wood or Masonry:

1.

Use a reinforcement patch to create a mesh net around the bolt. Leave

at least a 1" excess of mesh abound the diameter of the bolt. Push the

bolt and mesh through the hole.

2.

Remove the bolt and then fill the net 3/4-full with 3M™ Scotch-Weld™

Urethane Adhesive DP600 Self-Leveling or DP600NS while slowly

backing the nozzle out of the hole.

3.

Place the bolt in the hole and complete the fill, if necessary, to adjust

for any under-fill.

4.

Allow 3M™ Scotch-Weld™ Urethane Adhesive DP600 Self-Leveling

or DP600NS to fully cure before removing the bolt and reinstalling it

along with the supported load.

Installation

Instructions

(Continued)