DAC5687IPZP datasheet(64/72 Pages) TI

64 / 72 page

www.ti.com

B0040-01

NCO

DAC

Processing

TRF3750

GC4116

GC5016

GC5316

DUC

DAC5687

CDC7005

DAC5687

SLWS164B – FEBRUARY 2005 – REVISED JUNE 2005

Figure 73. System Diagram of a Real IF System Using the DAC5687

With the DAC5687 in external clock mode, a low phase noise clock for the DAC5687 at the DAC sample rate

would be generated by a VCXO and PLL such as Texas Instruments CDC7005, which can also provide other

system clocks at the VCXO frequency divided by 2-n (n = 0 to 4). In this mode, the DAC5687 PLLLOCK pin

output would typically be used to clock the digital upconverter. With the DAC in PLL clock mode, the same input

rate clock would be used for the DAC clock and digital upconverter and the DAC internal PLL/VCO would

generate the DAC sample rate clock. Note that the internal PLL/VCO phase noise may degrade the quality of the

DAC output signal, and will also have higher non-harmonic clock-related spurious signals (see the Non-Harmonic

Clock Related Spurious Signals section).

Either DACA or DACB outputs can be used (with the other DAC put into sleep mode) and would typically be

terminated with a transformer (see the Analog Current Output section). An IF filter, either LC or SAW, is used to

suppress the DAC Nyquist zone images and other spurious signals before being mixed to RF with a mixer.

An alternative architecture uses the DAC5687 in a dual-channel mode to create a dual-channel system with real

IF input and output. This would be used for narrower signal bandwidth and at the expense of less output

frequency placement flexibility (see Figure 74). Frequency upconversion can be accomplished by using the

high-pass filter and CMIX fDAC/2 mixing features.

DAC5687IPZP датащи(PDF) 64 Page - Texas Instruments