SSD1850 datasheet(18/56 Pages) ETC

18 / 56 page

SSD1850/51 Series

Rev 1.2

01/2003

SOLOMON

FUNCTIONAL BLOCK DESCRIPTIONS

Command Decoder and Command Interface

This module determines whether the input data is interpreted as data or command. Data is directed to this

module based upon the input of the D/ C pin. If D/ C is high, data is written to Graphic Display Data RAM

(GDDRAM). If D/ C is low, the input at D0-D7 is interpreted as a Command and it will be decoded and

written to the corresponding command register.

Reset is of the same function as Power ON Reset (POR). Once RES receives a negative reset pulse of

about 1us, all internal circuitry will be back to its initial status. Refer to Command Description section for

more information.

MPU Parallel 6800-series Interface

The parallel interface consists of 8 bi-directional data pins (D0-D7), R/W( WR ), D/ C , E( RD ) and CS .

R/W( WR )

input High indicates a read operation from the Graphic Display Data RAM (GDDRAM) or the

status register. R/W( WR ) input Low indicates a write operation to Display Data RAM or Internal

Command Registers depending on the status of D/ C input. The E( RD ) and CS input serves as data latch

signal (clock) when they are high and low respectively. Refer to P.35, Figure 1 of parallel timing

characteristics for Parallel Interface Timing Diagram of 6800-series microprocessors.

In order to match the operating frequency of display RAM with that of the microprocessor, pipeline

processing is internally performed which requires the insertion of a dummy read before the first actual

display data read. This is shown in Figure 4 below.

Figure 4 - display data read with the insertion of dummy read

MPU Parallel 8080-series interface

The parallel interface consists of 8 bi-directional data pins (D0-D7), R/W( WR ), E( RD ), D/ C and CS . The

input serves as data latch signal (clock) when it is low. Whether it is display data or status register

read is controlled by D/ C . R/W( WR ) and E( RD ) input indicate a write or read cycle when CS is low.

Refer to P.37, Figure 2 of parallel timing characteristics for Parallel Interface Timing Diagram of 8080-

series microprocessor.

Similar to 6800-series interface, a dummy read is also required before the first actual display data read.

R/W( WR )

Data bus

write column address

dummy read

data read1

data read 2

data read 3

n+1

n+2

E( RD )

SSD1850 датащи(PDF) 18 Page - List of Unclassifed Manufacturers

SSD1850 датащи(HTML) 18 Page - List of Unclassifed Manufacturers

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56

датащи скачать

ссылки URL