STM8S007C8 datasheet(44/92 Pages) STMICROELECTRONICS

44 / 92 page

Electrical characteristics

STM8S007C8

44/92

DocID022171 Rev 5

9.2

Absolute maximum ratings

Stresses above those listed as ‘absolute maximum ratings’ may cause permanent damage

to the device. This is a stress rating only and functional operation of the device under these

conditions is not implied. Exposure to maximum rating conditions for extended periods may

affect device reliability.

Table 13. Voltage characteristics

Symbol

Ratings

Min

Max

Unit

VDDx - VSS Supply voltage (including VDDA and VDDIO)

(1)

All power (VDD, VDDIO, VDDA) and ground (VSS, VSSIO, VSSA) pins must always be connected to the

external power supply

-0.3

6.5

VIN

Input voltage on true open drain pins (PE1, PE2)(2)

IINJ(PIN) must never be exceeded. This is implicitly insured if VIN maximum is respected. If VIN maximum

cannot be respected, the injection current must be limited externally to the IINJ(PIN) value. A positive

injection is induced by VIN>VDD while a negative injection is induced by VIN<VSS. For true open-drain pads,

there is no positive injection current, and the corresponding VIN maximum must always be respected

VSS - 0.3

6.5

Input voltage on any other pin(2)

VSS - 0.3

VDD + 0.3

|VDDx - VDD| Variations between different power pins

|VSSx - VSS| Variations between all the different ground pins

VESD

Electrostatic discharge voltage

see Absolute maximum

ratings (electrical

sensitivity) on page 81

STM8S007C8 датащи(PDF) 44 Page - STMicroelectronics