PM6675 datasheet(26/47 Pages) STMICROELECTRONICS

26 / 47 page

Obsolete

Product(s)

- Obsolete

Product(s)

Obsolete

Product(s)

- Obsolete

Product(s)

Device description

PM6675

26/47

It must be taken into account that the current limit circuit actually regulates the inductor

valley current. This means that RILIM must be calculated to set a limit threshold given by the

maximum DC output current plus half of the inductor ripple current:

Equation 21

The PM6675 provides also a fixed negative current limit to prevent excessive reverse

inductor current when the switching section sinks current from the load in forced-PWM (3rd

quadrant working conditions). This negative current limit threshold is measured between

PHASE and PGND pins, comparing the drop magnitude on PHASE pin with an internal

120mV fixed threshold.

6.1.6

POR, UVLO and Soft Start

The PM6675 automatically performs an internal startup sequence during the rising phase of

the analog supply of the device (AVCC). The switching controller remains in a stand-by

state until AVCC crosses the upper UVLO threshold (4.2V typ.), keeping active the internal

discharge MOSFETs (only if AVCC > 1V).

The soft-start allows a gradual increase of the internal current limit threshold during startup

reducing the input/output surge currents. At the beginning of start-up, the PM6675 current

limit is set to 25% of nominal value and the Under Voltage Protection is disabled. Then, the

current limit threshold is sequentially brought to 100% in four steps of approximately 750

µs

(Figure 13).

Figure 13. Soft-start waveforms

After a fixed 3ms total time, the soft-start finishes and UVP is released: if the output voltage

doesn't reach the Power-Good lower threshold within soft-start duration, the UVP condition

is detected and the device performs a soft end and latches off. Depending on the load

conditions, the inductor current may or may not reach the nominal value of the current limit

during the soft-start (Figure 14 shows two examples).

DSon

ILIM

100

⋅

SWEN

Current limit threshold

Switching output

Time

PM6675 датащи(PDF) 26 Page - STMicroelectronics

PM6675 датащи(HTML) 26 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47

датащи скачать

ссылки URL