| поискавой системы для электроныых деталей |
|
UM1539 датащи(PDF) 21 Page - STMicroelectronics |
|
|
|||||||||||||||||||||||||||||
UM1539 датащи(HTML) 21 Page - STMicroelectronics |
|
21 / 46 page ![]() UM1539 Getting started Doc ID 023106 Rev 1 21/46 button which returns the status of the memory being protected or not. Writing PSWP permanently protects the memory for read and write. Once the memory is permanently write protected then neither read nor write is possible for the lower half memory area. 4. To read the data byte at any specific location, select the location in the editable window and press the Read Byte button, it reads the selected location data from the sensor EEPROM and displays at the location in the editable area in the GUI. 5. The Read All button reads all the 256 bytes from the sensor EEPROM and displays it in the editable area. 6. To write a single byte at a specific location, change the byte value and press the Enter button on the computer. Then press Write Byte to write the data in the EEPROM. 7. To write all the 256 bytes of EEPROM, press the Write All button in the GUI. This writes the bytes as seen in the editable box. To change the bytes at the memory location, type the new value at that memory location and press Enter. To modify another memory location, go to that location, type the bytes and then press Enter. After all values are changed according to requirements, press Write All to program the values in the EEPROM. 8. Fill Buffer is used to fill the area of EEPROM with the same data byte. Type the memory location from where the data is to be written and also the destination memory location address. Then enter the data byte in the Fill With area. Pressing the Fill Buffer button programs the EEPROM selected area with selected data byte. This data byte can be seen in the GUI by pressing the Read All button. 9. Copy Block is used to copy the data from memory location 0x00-0x7F to the location 0x80-0xFF. Therefore both upper and lower 1 Kbit data is similar after the Copy Block command. 10. The settings for the EEPROM of the STTS424E02 sensor are shown in Figure 13. Figure 13. GUI window for EEPROM section of STTS2002 temperature sensor |
|
ссылки URL |
| Вашему бизинису помогли Аллдатащит? [ DONATE ] |
Что такое Аллдатащит | реклама | контакт | Конфиденциальность | Ссылка на техническое описание | обмен ссыками | поиск по производителю All Rights Reserved©Alldatasheet.com |
| Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
|
Family Site : ic2ic.com |
icmetro.com |