ML60.121

MiniLine-2

13. EMC

The power supply is suitable for applications in industrial environment as well as in residential, commercial and light

industry environment without any restrictions. A detailed EMC report is available on request.

EMC Immunity

Generic standards: EN 61000-6-1 and EN 61000-6-2

Electrostatic discharge

EN 61000-4-2

Contact discharge

Air discharge

8kV

8kV

Criterion A

Criterion A

Electromagnetic RF field

EN 61000-4-3

80MHz-2.7GHz

20V/m

Criterion A

Fast transients (Burst)

EN 61000-4-4

Input lines

Output lines

4kV

2kV

Criterion A

Criterion A

Surge voltage on input

EN 61000-4-5

L

N

N

PE, L

PE

2kV

4kV

Criterion A

Criterion A

Surge voltage on output

EN 61000-4-5

+

-

+

PE, -

PE

1kV

2kV

Criterion A

Criterion A

Conducted disturbance

EN 61000-4-6

0.15-80MHz

20V

Criterion A

Mains voltage dips

EN 61000-4-11

0% of 100Vac

40% of 100Vac

70% of 100Vac

0% of 200Vac

40% of 200Vac

70% of 200Vac

0Vac, 20ms

40Vac, 200ms

70Vac, 500ms

0Vac, 20ms

80Vac, 200ms

140Vac, 500ms

Criterion A *)

Criterion C

Criterion A

Criterion A

Criterion A

Criterion A

Voltage interruptions

EN 61000-4-11

0Vac, 5000ms

Criterion C

Input voltage swells

PULS internal standard

300Vac, 500ms

Criterion A

Powerful transients

VDE 0160

over entire load range

750V, 1.3ms

Criterion A

Criterions:

A:

Power supply shows normal operation behavior within the defined limits.

B:

The power supply operates continuously during and after the test. During the test minor temporary impairments may occur, which will be

corrected by the power supply itself.

C:

Temporary loss of function is possible. Power supply may shut-down and restarts by itself. No damage or hazards for the power supply

will occur.

*)

Up to 3A output current criterion A, above 3A output current criterion B

EMC Emission

Generic standards: EN 61000-6-3 and EN 61000-6-4

Conducted emission

EN 55011, EN 55022, FCC Part 15, CISPR 11, CISPR 22

Class B, input lines

Radiated emission

EN 55011, EN 55022, CISPR 11, CISPR 22

Class B

Harmonic input current

EN 61000-3-2

Not applicable below 75W

input power

Class A limits acc. to EN

61000-3-2 fulfilled.

Voltage fluctuations,

flicker *)

EN 61000-3-3

Fulfilled

This device complies with FCC Part 15 rules.

Operation is subjected to following two conditions: (1) this device may not cause harmful interference, and (2) this

device must accept any interference received, including interference that may cause undesired operation.

*) tested with constant current loads, non pulsing

Switching frequency

Converter frequency

variable, typ. 100kHz, min. 45kHz, max. 160kHz

Input voltage and output

load dependent

Nov. 2015 / Rev. 1.4 DS--ML60.121-EN

All parameters are specified at 12V, 4.5A, 230Vac 50Hz input, 25°C ambient and after a 5 minutes run-in time unless otherwise noted.

www.pulspower.com Phone +49 89 9278 0

Germany

11/23