ML60.121

MiniLine-2

All terminals are easy to access when mounted on the panel. Input and output terminals are separated from each

other (input below, output above) to help in error-free wiring.

Input

Output

Type

screw terminals

screw terminals

Solid wire

Stranded wire

American Wire Gauge

max. AWG10

max. AWG10

Wire stripping length

7mm / 0.275inch

7mm / 0.275inch

Screwdriver

3.5mm slotted or

Pozidrive No 2

3.5mm slotted or

Pozidrive No 2

Recommended tightening torque

1Nm, 9lb.in

1Nm, 9lb.in

Instructions:

a) Use appropriate copper cables that are designed for an operating temperature of:

60°C for ambient up to 45°C and 75°C for ambient up to 60°C minimum.

c) Ensure that all strands of a stranded wire enter the terminal connection!

d) Up to two stranded wires with the same cross section are permitted in one connection point (except PE wire).

e) Do not use the unit without PE connection.

f) Screws of unused terminal compartments should be securely tightened.

g) Ferrules are allowed.

These units are extremely reliable and use only the highest quality materials. The number of critical components such

as electrolytic capacitors has been reduced.

AC 100V

AC 120V

AC 230V

34 000h

41 000h

56 000h

at 12V, 4.5A and 40°C

180 000h *)

181 000h *)

128 000h *)

at 12V, 2.25A and 40°C

95 000h *)

115 000h *)

158 000h *)

at 12V, 4.5A and 25°C

1 327 000h

1 458 000h

1 690 000h

at 12V, 4.5A and 40°C

2 437 000h

2 639 000h

3 007 000h

at 12V, 4.5A and 25°C

1 085 000h

1 126 000h

1 067 000h

at 12V, 4.5A and 40°C; Ground Benign GB40

1 464 000h

1 520 000h

1 445 000h

at 12V, 4.5A and 25°C; Ground Benign GB25

*)

The Lifetime expectancy shown in the table indicates the minimum operating hours (service life) and is determined by the lifetime

expectancy of the built-in electrolytic capacitors. Lifetime expectancy is specified in operational hours and is calculated according to the

capacitor’s manufacturer specification. The manufacturer of the electrolytic capacitors only guarantees a maximum life of up to 15 years

(131 400h). Any number exceeding this value is a calculated theoretical lifetime which can be used to compare devices.

**) MTBF stands for Mean Time Between Failure, which is calculated according to statistical device failures, and indicates reliability of a

device. It is the statistical representation of the likelihood of a unit to fail and does not necessarily represent the life of a product.

The MTBF figure is a statistical representation of the likelihood of a device to fail. A MTBF figure of e.g. 1 000 000h means that

statistically one unit will fail every 100 hours if 10 000 units are installed in the field. However, it can not be determined if the failed unit

has been running for 50 000h or only for 100h.

Nov. 2015 / Rev. 1.4 DS--ML60.121-EN

All parameters are specified at 12V, 4.5A, 230Vac 50Hz input, 25°C ambient and after a 5 minutes run-in time unless otherwise noted.

www.pulspower.com Phone +49 89 9278 0

Germany

10/23