Data Sheet

ADRF5130

Rev. A | Page 9 of 10

Figure 14 shows the ADRF5130 evaluation board with all

components populated. The VDD supply port connects to TP1.

The VDD supply trace has three bypass capacitors 100 pF, 1 µF,

and 1 nF. The TP2 test point connects to the control voltage

port (VCTL). The control trace has a 100 pF bypass capacitor

and 0 Ω resistor. The ground reference connects to GND. A

100 pF dc blocking capacitor is used on all RF traces that connect

the RF1, RF2, and RFC ports to the J1, J2, and J3 connectors,

respectively. The connectors used are 2.9 mm end launch SMA

connectors. Unpopulated capacitor positions are available on all

RF traces to provide extra matching. A through transmission

line (THRU CAL) is available on theADRF5130 evaluation board

that can measure board loss on the printed circuit board (PCB).

Table 6 shows the bill of materials for the ADRF5130 evaluation

board. The evaluation board shown in Figure 14 is available

from Analog Devices, Inc., upon request.

J3

J2

J1

U1

C7

R1

TP1

TP2

TP3

C1

C2

C3

600-01532-00-2

RFC

VDD

GND

VCTL

1

2

3

4

Figure 14. ADRF5130-EVALZ Evaluation Board

Table 6. Bill of Materials for the ADRF5130-EVALZ Evaluation Board

Reference Designator

Description

J1 to J3

PCB mount SMA connectors

C1 to C4, C7

100 pF capacitors, 0402 package

C5

1 nF capacitor, 0402 package

C6

1 µF capacitor, 0402 package

C8 to C15, C18 to C21

Do not insert (DNI)

R1

0 Ω resistor, 0402 package

TP1, TP2, TP3

Surface-mount test points

U1

ADRF5130 SPDT switch

PCB

1

Reference this evaluation board number when ordering the complete evaluation board.