| поискавой системы для электроныых деталей |
|
AR0141CS датащи(PDF) 19 Page - ON Semiconductor |
|
|
|||||||||||||||||||||||||||||
AR0141CS датащи(HTML) 19 Page - ON Semiconductor |
|
19 / 64 page ![]() AR0141CS/D Rev. 6, 4/16 EN 19 ©Semiconductor Components Industries, LLC, 2016. AR0141CS: 1/4-Inch Digital Image Sensor Data Pedestals Data Pedestals The data pedestal is a constant offset that is added to pixel values at the end of the data- path. The default offset is 168 and is a 12-bit offset. This offset matches the maximum range used by the corrections in the digital readout path. The purpose of the data pedestal is to convert negative values generated by the digital datapath into positive output data. Reset The AR0141CS may be reset by the RESET_BAR pin (active LOW) or the reset register. Hard Reset of Logic The host system can reset the image sensor by bringing the RESET_BAR pin to a LOW state. Alternatively, the RESET_BAR pin can be connected to an external RC circuit for simplicity. Registers written via the two-wire interface will not be preserved following a hard reset. Soft Reset of Logic Soft reset of logic is controlled by the R0x301A Reset register. Bit 0 is used to reset the digital logic of the sensor. Furthermore, by asserting the soft reset, the sensor aborts the current frame it is processing and starts a new frame. This bit is a self-resetting bit and also returns to “0” during two-wire serial interface reads. Clocks The AR0141CS requires one clock input (EXTCLK). Sensor PLL VCO Figure 18: PLL Dividers Affecting VCO Frequency The sensor contains a phase-locked loop (PLL) that is used for timing generation and control. The required VCO clock frequency is attained through the use of a pre-PLL clock divider followed by a multiplier. The PLL multiplier should be an even integer. If an odd integer (M) is programmed, the PLL will default to the lower (M-1) value to maintain an even multiplier value. The multiplier is followed by a set of dividers used to generate the output clocks required for the sensor array, the pixel analog and digital readout paths, and the output parallel and serial interfaces. EXTCLK (6-50 MHz) pre_pll_clk_div 2 (1-64) pll_multiplier 58 (32-384) F VCO |
|
ссылки URL |
| Вашему бизинису помогли Аллдатащит? [ DONATE ] |
Что такое Аллдатащит | реклама | контакт | Конфиденциальность | Ссылка на техническое описание | обмен ссыками | поиск по производителю All Rights Reserved©Alldatasheet.com |
| Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
|
Family Site : ic2ic.com |
icmetro.com |