LP5523 datasheet(6/56 Pages) TI1

6 / 56 page

LP5523

SNVS550D – SEPTEMBER 2009 – REVISED MAY 2013

www.ti.com

Logic Interface Characteristics

(1)(2)(3)

(continued)

Symbol

Parameter

Condition

Min

Typ

Max

Units

Output Leakage Current

VOUT = 2.8V

1.0

µA

Recommended External Clock Source Conditions

(1) (2) (3) (4) (5)

Symbol

Parameter

Condition

Min

Typ

Max

Units

Logic input CLK

fCLK

Clock Frequency

32.7

kHz

tCLKH

High Time

µs

tCLKL

Low Time

µs

Clock Rise Time

10% to 90%

µs

Clock Fall Time

90% to 10%

µs

(1)

The Electrical characteristics tables list ensured specifications under the listed Recommended Conditions except as otherwise modified

or specified by the Electrical Characteristics Conditions and/or Notes. Typical specifications are estimations only and are not ensured.

(2)

All voltages are with respect to the potential at the GND pin.

(3)

Min and Max limits are ensured by design, test, or statistical analysis.

(4)

Specification is ensured by design and is not tested in production. VEN = 1.65V to VDD.

(5)

The ideal external clock signal for the LP5523 is a 0V to VEN 25% to 75% duty-cycle square wave. At frequencies above 32.7 kHz,

program execution will be faster, and at frequencies below 32.7 kHz program execution will be slower.

Serial Bus Timing Parameters (SDA, SCL)

(1) (2) (3) (4)

Symbol

Parameter

Limit

Units

Min

Max

fSCL

Clock Frequency

400

kHz

Hold Time (repeated) START Condition

0.6

µs

Clock Low Time

1.3

µs

Clock High Time

600

Setup Time for a Repeated START Condition

600

Data Hold Time

Data Setup Time

100

Rise Time of SDA and SCL

20+0.1 Cb

300

Fall Time of SDA and SCL

15+0.1 Cb

300

Set-up Time for STOP condition

600

Bus Free Time between a STOP and a START Condition

1.3

µs

Capacitive Load Parameter for Each Bus Line.

200

Load of One Picofarad Corresponds to One Nanosecond.

(1)

The Electrical characteristics tables list ensured specifications under the listed Recommended Conditions except as otherwise modified

or specified by the Electrical Characteristics Conditions and/or Notes. Typical specifications are estimations only and are not ensured.

(2)

All voltages are with respect to the potential at the GND pin.

(3)

Min and Max limits are ensured by design, test, or statistical analysis.

(4)

Specification is ensured by design and is not tested in production. VEN = 1.65V to VDD.

Submit Documentation Feedback

Product Folder Links: LP5523

LP5523 датащи(PDF) 6 Page - Texas Instruments

LP5523 датащи(HTML) 6 Page - Texas Instruments

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56

датащи скачать

ссылки URL