ADC1241 datasheet(5/14 Pages) NSC

5 / 14 page

AC Electrical Characteristics (Continued)

Note 7

A diode exists between AVCC and DVCC as shown below

TLH10554 – 4

To guarantee accuracy it is required that the AVCC and DVCC be connected together to a power supply with separate bypass filters at each VCC pin

Note 8

Accuracy is guaranteed at fCLK e 20 MHz At higher and lower clock frequencies accuracy may degrade See curves in the Typical Performance

Characteristics Section

Note 9

Typicals are at TJ e 25 C and represent most likely parametric norm

Note 10

Limits are guaranteed to National’s AOQL (Average Outgoing Quality Level)

Note 11

Positive linearity error is defined as the deviation of the analog value expressed in LSBs from the straight line that passes through positive full scale and

zero For negative linearity error the straight line passes through negative full scale and zero (See

Figures 1b and 1c )

Note 12

The ADC1241’s self-calibration technique ensures linearity full scale and offset errors as specified but noise inherent in the self-calibration process will

result in a repeatability uncertainty of g020 LSB

Note 13

If TA changes then an Auto-Zero or Auto-Cal cycle will have to be re-started see the typical performance characteristic curves

Note 14

After an Auto-Zero or Auto-Cal cycle at the specified power supply extremes

Note 15

If the clock is asynchronous to the falling edge of WR an uncertainty of one clock period will exist in the interval of tA therefore making the minimum tA e

6 clock periods and the maximum tA e 7 clock periods If the falling edge of the clock is synchronous to the rising edge of WR then tA will be exactly 65 clock

periods

Note 16

The CAL line must be high before any other conversion is started

Note 17

The specifications for these parameters are valid after an Auto-Cal cycle has been completed

Note 18

A military RETS electrical test specification is available on request At time of printing the ADC1241CMJ883 RETS specification complies fully with the

boldface limits in this column

TLH10554 – 5

FIGURE 1a Transfer Characteristic

ADC1241 датащи(PDF) 5 Page - National Semiconductor (TI)

ADC1241 датащи(HTML) 5 Page - National Semiconductor (TI)

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14

датащи скачать

ссылки URL