AS3955 datasheet(60/111 Pages) AMSCO

60 / 111 page

Page 60

ams Datasheet

Document Feedback

[v1-01] 2015-Apr-29

AS3955 − Detailed Description

Word Address Byte

Both EEPROM modes (Read and Write) use Word Address byte

to define the address of the EEPROM word which is accessed.

Seven MSB bits of the Address Byte are used to define the

address; while the last bit is don’t care (it is used to synchronize

EEPROM access).

Figure 62:

EEPROM Block Address Byte

EEPROM Write

In order to program an EEPROM block, six bytes shall be sent

(mode byte, block address byte and 4 bytes of data, all of them

MSB first). Actual EEPROM programming is started with rising

/SS edge signal which terminates the EEPROM Write command.

EEPROM Read

In order to read data from EEPROM, first a mode byte is sent,

followed by the block address byte (MSB first). Then one or more

blocks of data with address auto-incrementing (packets of 4

bytes) are transferred to MISO output, also MSB first. MOSI is

sampled at the SCLK falling edge; data to be read from AS3955

EEPROM is driven to MISO pin on SCLK rising edge and is

sampled by the master at the SCLK falling edge. In case the

block on the defined address does not exist, all 0 data is sent to

MISO.

Please note that SCLK frequency should not exceed 1MHz

during EEPROM Read (limited by EEPROM read access time).

Figure 63:

Reading an EEPROM Block over SPI

EEPROM Block Address

WA6

WA5

WA4

WA3

WA2

WA1

WA0

01 1 1 1 1 1 1

MSB Byte from Address

<WA6-WA0>

/SS

SCLK

MOSI

LSB Byte from Address

<WA6-WA0>

MISO

1µs min

AS3955 датащи(PDF) 60 Page - ams AG

AS3955 датащи(HTML) 60 Page - ams AG

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

датащи скачать

ссылки URL