LTC1516CS8 datasheet(7/8 Pages) LINER

7 / 8 page

LTC1516

APPLICATIONS INFORMATION

Paralleling Devices

Two or more LTC1516’s may be connected in parallel to

provide higher output currents. The VIN, VOUT, GND and

SHDN pins may be tied together, but the C1 and C2 pins

must be kept separate (see Figure 5). Separate CIN and

COUT capacitors may be required to reduce output noise

and ripple if the paralleled devices cannot be kept close

together. Otherwise, single CIN and COUT capacitors may

be used with each being 2

× (or 3× if three parts are

paralleled, etc.) in value.

General Layout Considerations

Due to the high switching frequency and high transient

currents produced by the LTC1516, careful board layout is

a must. A clean board layout using a ground plane and

short connections to all capacitors will improve perfor-

mance and ensure proper regulation under all conditions

(refer to Figure 6).

COUT

CIN

VOUT

VIN

1516 • F06

LTC1516

SHDN

GND

Figure 6. Suggested Component Placement for LTC1516

Information furnished by Linear Technology Corporation is believed to be accurate and reliable.

However, no responsibility is assumed for its use. Linear Technology Corporation makes no represen-

tation that the interconnection of its circuits as described herein will not infringe on existing patent rights.

C1–

SHDN

GND

C2–

C1+

VIN

VOUT

C2+

LTC1516

0.22

µF

ON/OFF

µF

VOUT = 5V ±4%

IOUT = 0mA TO 40mA, VIN ≥ 2V

IOUT = 0mA TO 100mA, VIN ≥ 3V

0.22

µF

VIN = 2V

TO 5V

1516 • F05

C1–

SHDN

GND

C2–

C1+

VIN

VOUT

C2+

LTC1516

0.22

µF

0.22

µF

Figure 5. Paralleling Devices

LTC1516CS8 датащи(PDF) 7 Page - Linear Technology

LTC1516CS8 датащи(HTML) 7 Page - Linear Technology

Html Pages

1 2 3 4 5 6 7 8

датащи скачать

ссылки URL