| поискавой системы для электроныых деталей |
|
AN4488 датащи(PDF) 37 Page - STMicroelectronics |
|
|
|||||||||||||||||||||||||||||
AN4488 датащи(HTML) 37 Page - STMicroelectronics |
|
37 / 44 page ![]() DocID026304 Rev 3 37/44 AN4488 Reference design 43 8 Reference design 8.1 Description The reference design shown in Figure 26, is based on the STM32F407IG(H6), a highly integrated microcontroller running at 168 MHz, that combines the Cortex®-M4 32-bit RISC CPU core with 1 Mbyte of embedded Flash memory and 192+4 Kbytes of SRAM including 64-Kbytes of CCM (core coupled memory) data RAM . This reference design is intended to work with a VDD from 1.8V minimum (PDR_ON = VDD_MCU) and using embedded voltage regulator for 1.2V core supplies (BYPASS_REG = GND), although BYPASS_REG = VDD_MCU is possible with JP1 jumper change, the additional hardware as described in Section 2.3.6 is not present. This reference design can be tailored to any other device listed in Table 1 with different package, using the pins correspondence given in Table 12: Reference connection for all packages. 8.1.1 Clock Two clock sources are used for the microcontroller: • LSE: X2– 32.768 kHz crystal for the embedded RTC • HSE: X1– 25 MHz crystal for the STM32F4xxxx microcontroller Refer to Section 4: Clocks on page 26. 8.1.2 Reset The reset signal in Figure 26 is active low. The reset sources include: • Reset button (B1) • Debugging tools via the connector CN1 Refer to Section 2.3: Reset & power supply supervisor on page 10. 8.1.3 Boot mode The boot option is configured by setting switches SW2 (Boot 0) and SW1 (Boot 1). Refer to Section 5: Boot configuration on page 30. Note: In low-power mode (more specially in Standby mode) the boot mode is mandatory to be able to connect to tools (the device should boot from the SRAM). 8.1.4 SWJ interface The reference design shows the connection between the STM32F4xxxx and a standard JTAG connector. Refer to Section 6: Debug management on page 32. Note: It is recommended to connect the reset pins so as to be able to reset the application from the tools. 8.1.5 Power supply Refer to Section 2: Power supplies on page 7. |
|
ссылки URL |
| Вашему бизинису помогли Аллдатащит? [ DONATE ] |
Что такое Аллдатащит | реклама | контакт | Конфиденциальность | Ссылка на техническое описание | обмен ссыками | поиск по производителю All Rights Reserved©Alldatasheet.com |
| Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
|
Family Site : ic2ic.com |
icmetro.com |