UM0272 datasheet(30/40 Pages) STMICROELECTRONICS

30 / 40 page

Menus

UM0272

30/40

Description

The Partitions description is 16 characters long and is displayed on the Log Event (see

Section 5.5: Log event) menus. This displays a more significant name rather than a number.

To change the description, press ENT, enter the new text and press ENT again to store the

new description.

Input

The Input sub-menu associates the selected partition to one or more zones installed on the

system. Press ENT to display the association menu (Figure 25) and the first 8 zones

hardwired on the CU. If more zones are present on the system by means of one or more IO

Expander, press

to display the next group of 8 zones. Press

to scroll through

each displayed zone. To associate the partition to selected zone, press ENT. The symbol

displayed after the zone number will change from a dot (.) to a plus sign (+).

Output

Similar to the Input sub-menu, this sub-menu associates partitions and zones that will be

monitored once the selected partition is activated.

Figure 25.

Input and output association menu

5.6.4

Installation code

For security reasons, an installation code is required to enter the CU in Setup mode using

any programming device (either a Control Module or the PC GUI). The factory value (both

for the CU and the CM) for the installation code is 00000000.

Changing the installation code from this menu affects both the installation code of the CU of

the CM programming the CU. If more than one CM is installed on the system, the old

installation code must be changed manually for each module. See Section 5.7: CM Setup

for more information about changing the installation code for Control Modules.

Figure 26.

Installation code menu

UM0272 датащи(PDF) 30 Page - STMicroelectronics