UM0272 datasheet(28/40 Pages) STMICROELECTRONICS

28 / 40 page

Menus

UM0272

28/40

Figure 22.

Output settings menus

Description

The Output description is 16 characters long and is displayed on the System Status

(Section 5.4: System status) and Log Event (see Section 5.5: Log event) menus. This

displays a more significant name rather than a number. To change the description, press

ENT, enter the new text and press ENT again to store the new description.

Status

The Status sub-menu adds or removes the selected output from the control flow. Once

disabled, the output will not be activated by the CU even if associated to a zone where an

alarm condition is detected.

This option is used for disabling the output if it is not used, if a sensor connected on it is

broken (waiting for a replacement) or to temporarily disable the output without losing any

settings. Press ENT to switch between the two possible values (enabled/disabled).

Working mode

The Working mode indicates the way the output is managed once enabled and associated

to a zone. The possible working mode values are the following:

●

Change Status: The CU changes the output value during an alarm condition and

restores the previous value once the time associated to the output is elapsed.

●

Toggle: The CU toggles the output value each time it detects an alarm condition. In

order to switch between the different working modes, press ENT.

●

Default Level: The default level can be normally high (the SSR outputs and the

transistorized outputs are at 12 VDC level, the Relay will close the contacts between

the C and NA terminals, the Buzzer is normally activated) or normally low (the opposite

UM0272 датащи(PDF) 28 Page - STMicroelectronics