ADN2811 datasheet(13/20 Pages) AD

13 / 20 page

ADN2811

Rev. B | Page 13 of 20

The ADN2811 can accept any of the following reference clock

frequencies: 19.44 MHz, 38.88 MHz, 77.76 MHz at LVTTL/

LVCMOS/LVPECL/LVDS levels, or 155.52 MHz at LVPECL/

LVDS levels via the REFCLKN/P inputs, independent of data

rate. The input buffer accepts any differential signal with a

peak-to-peak differential amplitude of greater than 100 mV

(e.g., LVPECL or LVDS) or a standard single-ended low voltage

TTL input, providing maximum system flexibility. The

appropriate division ratio can be selected using the REFSEL0/1

pins, according to Table 5. Phase noise and duty cycle of the

reference clock are not critical, and 100 ppm accuracy is

sufficient.

REFSEL must be tied to VCC when the REFCLKN/P inputs are

active, or tied to VEE when the oscillator is used. No connection

between the XO pin and REFCLK input is necessary (see

Figure 14, Figure 15, and Figure 16). Note that the crystal should

operate in series resonant mode, which renders it insensitive to

external parasitics. No trimming capacitors are required.

LOCK DETECTOR OPERATION

The lock detector monitors the frequency difference between

the VCO and the reference clock and deasserts the loss of lock

signal when the VCO is within 500 ppm of center frequency

(see Figure 17). This enables the phase loop, which pulls the

VCO frequency in the remaining amount and also acquires

phase lock. Once locked, if the input frequency error exceeds

1000 ppm (0.1%), the loss of lock signal is reasserted and

control returns to the frequency loop, which reacquires and

maintains a stable clock signal at the output.

Table 5. Reference Frequency Selection

REFSEL

REFSEL[1..0]

Applied Reference

Frequency (MHz)

19.44

38.88

77.76

155.52

REFCLKP/N Inactive. Use 19.44 MHz

XTAL oscillator on Pins XO1, XO2 (Pull

REFCLKP to VCC).

The frequency loop requires a single external capacitor between

CF1 and CF2. The capacitor specification is given in Table 7.

Table 7. Recommended CF Capacitor Specification

Parameter

Value

Temperature Range

−40°C to +85°C

Capacitance

>3.0 µF

Leakage

<80 nA

Rating

>6.3 V

An on-chip oscillator to be used with an external crystal is also

provided as an alternative to using the REFCLKN/P inputs.

Details of the recommended crystal are given in Table 6.

Table 6. Required Crystal Specifications

Parameter

Value

Mode

Series Resonant

Frequency/Overall Stability

19.44 MHz ±100 ppm

Frequency Accuracy

±100 ppm

Temperature Stability

±100 ppm

Aging

±100 ppm

ESR

50 Ω max

1000

500

1000

fVCO ERROR

(ppm)

LOL

Figure 17. Transfer Function of LOL

ADN2811 датащи(PDF) 13 Page - Analog Devices

ADN2811 датащи(HTML) 13 Page - Analog Devices

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20

датащи скачать

ссылки URL